I guess that it comes down to these considerations:
1. that any "out of whack" is almost eliminated (as you say, before going to market)
2. the cost is presumably similar to normal pads/cups
3. there would be no "bad factory setup" or shop "tuneup" needed at the point of selling
4. they would need to be fitted to a sax that people were interested in buying (for the reasons we list as saxes being desirable to buy)
5. if they could be knocked out of whack in transit between gigs, then they can be reset - thus enabling your own reset before any gig
So why am I not excited?
Put them on a Yani or Yam and I'd still not be excited - it's not my sax. So then we're into retrofitting...
Well my original intention was that they'd be retrofittable and indeed they are.
With pad costs spiralling they'd likely be cheaper, at least to start with until they get a foot hold in the market.
They need ONE total dismantle of the sax to glue the magnets into the key cups. This would be a tech or official installer job OR could be a DIY fit by a competent owner who can also do adjustment and regulation.
I can do this up to a point but would always want a tech to check my work as I'm not an expert. Hence my prototypes go to a well regarded tech who has been a great help so far albeit not sold on the idea.
After the initial magnet install, pad replacement needs no dismantling for the majority of pads. There are a few which get trapped by key guards. posts, etc. but these aren't in the main stacks which is a blessing. To replace all pads would take around an hour including initial individual pad height adjustment, as under.
Users could replace their own pads after the initial installation so long as the incoming pad has any height adjustment shims (washers) transferred from the outgoing pad screw. In practice users would likely want their tech to do this work. It's far quicker than a traditional re-pad. No glue necessary.
In transit by courier a few of the larger pads have become dislodged. These are simply pushed back until they click into place in the magnet. In everyday transit by the owner this is unlikely to occur. A new retaining magnet has been custom made to stop larger pads, because of their mass, from dropping out in transit. These are to have their first fit after bench testing in the "final" alto and tenor prototypes awaiting the outsourced pre-cut pads coming to me shortly. These will go to the tech for a final set-up before doing the rounds amongst players here, pro and amateur, as previously.
My "small business" alternative to retail and repairer routes would involve taking your sax Pete, fitting my pads, and off you go. If you don't like them you can refit traditional pads by removing the magnets. I use a pair of mole grips to break the magnet out and then remove any adhering debris in the cup. The cups are unharmed!
As for OEM fit, that would be good... please phone Yani and set up a meeting for me!
OEM could go further, such as doing away with key cups entirely for lightness which excites me but for which I don't have the engineering skills or equipment to try. I think the retro fit pads would have to get some rave reviews before a large manufacturer would be at all interested. Yes I know... hire a stand at NAMM. Any pro players here fancy a trip to California to demonstrate my pads and prototypes to the world?
But... let's not run before we can walk eh?...