- Messages
- 8,133
- Location
- Near Evesham, Worcestershire
Mine too. Paul Carrington completely re-padded my SA80II with hot glue. Is that sacrilege?
It is not uncommon for manufacturers to use too little shellac on the backs of pads. It is probably a cost thing. The shellac wasn't the problem, it was there was not enough shellac to reposition or "float" the pad. Most techs have their own likes and dislikes, but I think some mistake poor installation technique with the quality of the adhesive. They are really two different things.My sax tech can't stand shellac!
He has just replaced the G# pad on my 2 year old alto because he couldn't get it to seal properly because of the shellac that was used in manufacture.
I have no idea what he does use, but I know he has mentioned his dislike of shellac before.

It is not uncommon for manufacturers to use too little shellac on the backs of pads. It is probably a cost thing. The shellac wasn't the problem, it was there was not enough shellac to reposition or "float" the pad. Most techs have their own likes and dislikes, but I think some mistake poor installation technique with the quality of the adhesive. They are really two different things.
Get them direct from the makers in Italy.
Pads & Accessory for Wind Instruments | Music Center S.p.A.
Good point. I have seen a pattern in which the backs of the pads are "light" right from the factory. My "theory" is that the pads are seated using the method you describe, and since the front of the key cup moves father than the back there is a deeper impression made at the front when it appears the pad is perfectly seated. Then, over time, the deeper indentation relaxes a bit pushing the pad up a bit causing the back to be light. I am interested to know what you think.Yep, it a cost thing - but not in terms of how much shellac (or any other kind of glue) is use. It's all about the time and skill it takes to properly seat a pad. Modern manufacturing relies on getting the cup angles consistent and then using the appropriate thickness of pad...and then compression seating them. Too much glue, or even very much at all, and it'd ooze out of the keycups.
Cheapest pad set for alto £90 inc postage
Good point. I have seen a pattern in which the backs of the pads are "light" right from the factory. My "theory" is that the pads are seated using the method you describe, and since the front of the key cup moves father than the back there is a deeper impression made at the front when it appears the pad is perfectly seated. Then, over time, the deeper indentation relaxes a bit pushing the pad up a bit causing the back to be light. I am interested to know what you think.
They do individual ones, and I just need 5.
From Dawkes today, the ETA for the GSL0900 and GSP1800 is end of November 2018 and the ETA for GSP4000 is end of January 2019 - of course, all popular sizes so we constantly have them on order given they can take 4-8 months to arrive as they are hand made."
Hey, what!? FOUR months for pads to arrive?
These would be quicker: Professional Set of 25pcs Alto Saxophone Woodwind Leather Pads, Sax Accessory | eBay![]()
