Having had the 'Venus' bari for a few months now, I feel that I can now give it a fair appraisal.
A visual inspection revealed some very minor acid bleed, but apart from that it looked well set up and impressive.
The first attempts at playing scales with the m'piece (Chinese, tip opening about 0.100") supplied and using a Fibracell reed, showed that the sax had indeed been well set up, with all notes sounding cleanly (I was really surprised as this was a new reed straight out of the box!). The m'piece though, did, I feel let the sound down. So a Metalite M7 was ordered!
Upon examination of the m'piece, to my inspectors eye, the machining of the table wasn't concentric to the chamber opening and so required reworking. I spent half an hour rubbing it back and forth on a sheet of glass paper, while applying pressure to one side,so as to correct the error. After that it played perfectly!
Now we come to the main problem, and this is serious and to be watched out for!!!!!
After a week of playing, I thought that the m'piece was getting loose on the cork, as it appeared to be moving up and down.
I was mistaken, it was the neck socket that had come away from the body!!
What had happened was that the two screws that hold the bracing strut (that fits between the body and neck socket), had not been fully tightened. Which meant that the full leverage from the neck/ m'piece, was being transmitted directly to the socket, resulting in the failure of the soldered joint!
Now some will say that I should have sent it straight back to the supplier, but as I had successfully made the same repair before (to a tenor sax), I couldn't be bothered with the hassle.
The repair was quite simple. All it involved was to thoroughly clean up the soldered area, mask off the surrounding lacquer and using an incredible adhesive called J-B Weld (tensile strength 3,600 PSI) glue the socket back in place, fit the bracing strut. Leave for 24 hours, and that was that. No visible sign of a repair (probably stronger than original!).
I did contact the supplier and inform him of the problem of both the socket and the mouthpiece. He was of course most apologetic and said he would inform the manufacturer.
So the lesson is, always check all screws for tightness.
Am I satisfied with my 'Venus' bari. - YOU BET, I'm over the moon with it (my wife says that I would take it to bed with me if I could!). Would I recommend it - Yes - but do check all screws for tightness!!!!!
As for the m'piece,
After rework, it performs perfectly. I love the sound and use it all of the time. I just need a new set of lungs
John
🙂;}