Try no neck screw if the tenon is snug
Hello, John. This is not pointed at you. This is in defence of my methodology on how I treat my sax.
There is one sax I have that has this snug problem. It is my 1990's Le Blanc 7133T Vito tenor. At times I have put a very light wipe of cork grease, which makes it fit and the tenon screw tightens it down nicely without binding or overtightening.
I know this goes cross grain with some traditionalists who will swear by doing such is a way to enter dust and dirt, cause overtightening the screw to cause thread stress and strippage, and ad nauseum. (One will wear out the threads on that screw quickly if there is no lubricant on the screw threads.)
No, for one, that joint is only briefly exposed to the environment when mounting the neck. When removed, the end plug that protects the octave pin is replaced when storing in the case. Case inside is a relatively dust-free environment.
Also it is very easy to clean off with a paper towel or rag. And, it doesn't turn while I'm playing because of a little lubricant.
And at times I have put a very light wipe of cork grease on a tenon screw threads, so it acts like it is lubricated. I don't carry key oil in my case for obvious reasons.
To both of these measures, I may have to do it once say every 6 months.
(Ever have a squeaky door hinge on a car? I take the oil or automatic transmission oil dip stick, put a drop on the hinges. Works until I get more time to further lubricate it in my home garage. Saves me buying new door hinge pins.)
(Or, car is a quart low on oil. So I put the only oil I have on hand, because I am out in the middle of nowhere with a quart of automatic transmission fluid. Engine will stay lubricated until I get home, where I can change it. A lack of oil can permanently damage an engine, requiring expensive rebuilding or replacing.)
And again, it is easily reversed with no harm done. And, they are with my personal instruments, which I have latitude into how I treat. And, similar to a motorcyclist never criticises another's ride but shows due respect, neither do I comment on another's sax or how they treat it, unless they are asking for opinions.
There are a lot more creative ways to destroy a sax than a simple wipe of cork grease. A simple wipe of cork grease on that squeaky tenon screw will help preserve the softer brass threads without damage. YMMV.
It is a part of my playing safe sax.
