- Messages
- 8,133
- Location
- Near Evesham, Worcestershire
I just finished re-padding a previously unplayable 50's Beaugnier tenor.
Plays fine, although unsurprisingly not as well as its Yani or Yamaha room-mates.
Part of this could be due to distraction as it gives me noticable discomfort via its original thumb hook compared to the more modern adjustable thumb hooks of the others, PLUS the positioning of the Beaugnier's hook (centre below) is slightly further to the left, smaller, and lower down...
My immediate thoughts are to have a more modern adjustable hook fitted in a similar position. Something like this?...
If I go this route I'd need to get a tech to solder it on. I'm not bothered by the scar or lacquer loss as the horn has patina already. As an aside I'm currently using a strong 2 part metal to metal structural adhesive with 15.0 N/mm² shear strength but feel a little nervous doing a DIY bond on such an important fixture.
Any other suggestions aside from this route? One of these perhaps...
Thanks for any input.
🙂
Plays fine, although unsurprisingly not as well as its Yani or Yamaha room-mates.
Part of this could be due to distraction as it gives me noticable discomfort via its original thumb hook compared to the more modern adjustable thumb hooks of the others, PLUS the positioning of the Beaugnier's hook (centre below) is slightly further to the left, smaller, and lower down...
My immediate thoughts are to have a more modern adjustable hook fitted in a similar position. Something like this?...
If I go this route I'd need to get a tech to solder it on. I'm not bothered by the scar or lacquer loss as the horn has patina already. As an aside I'm currently using a strong 2 part metal to metal structural adhesive with 15.0 N/mm² shear strength but feel a little nervous doing a DIY bond on such an important fixture.
Any other suggestions aside from this route? One of these perhaps...
Thanks for any input.
🙂
