Tech/maintenance Replacing corks and felts; basics?

Another excellent design is the triple point body to bell brace found on Cannonball tenors and baritones. I prefer to use 20 min epoxy in addition to the "mechanical" tightening ring to secure the body to bell connection. In my view soldering provides no acoustical advantage and adds to the chance of cosmetic damage to the finish when soldering and unsoldering the connection. The epoxy properly applied supplies a strong bond that can be released when needed without using excessive heat. Other techs may disagree.

shwwimg_cannonball_tenor_bellbrace.jpg
 
The thing about that three point mount is that while it's quite stiff fore and aft, it's not very stiff at all against movement to left or right. You've just got a piece of 1/8" sheet metal resisting movement in bending. Using epoxy (or, to be honest, soldering) at the three screw joints really only adds lateral stiffness if the joints were poorly designed in the first place, like unflat mounts.

That three point mount needs to be rotated 90 degrees. It would still be stiff fore and aft, but it would also resist any kind of lateral motion of the bell. Then soldering the bell to bow and bow to tube joints would prevent twisting of the bell about its axis.
 
The thing about that three point mount is that while it's quite stiff fore and aft, it's not very stiff at all against movement to left or right. You've just got a piece of 1/8" sheet metal resisting movement in bending. Using epoxy (or, to be honest, soldering) at the three screw joints really only adds lateral stiffness if the joints were poorly designed in the first place, like unflat mounts.

That three point mount needs to be rotated 90 degrees. It would still be stiff fore and aft, but it would also resist any kind of lateral motion of the bell. Then soldering the bell to bow and bow to tube joints would prevent twisting of the bell about its axis.
The thing about *that* three point mount is that it's a four point mount - it has an additional brace that extends perpendicular to the main brace and is fixed to the apex of the main body tube. Such braces have become more common in recent years - but they really ought to be a standard fitment on all curved saxes.

I'm with JBT on the bottom bow joint; soldering the joint adds very little stiffness and no acoustic benefits - and in the event of a knock it's very rarely the case that the joint has given way, rather it's the bottom bow tube that distorts.
 
I think I see the extra brace that would make it a four point brace. In that case, all my comments are withdrawn, as that would be a good stout brace that gives stiffness in all directions. But many Selmer copies have just the three points, which is still better than the one wee wire, but not as good as either the X brace or the four-pointer.
 
Then only proximate cause I can think of is the cold (-10 to -15⁰ here) / low humidity snap causing some manly shrinkage?
Well, here we are again, on the cooler side.

So, today the low C, B, B♭ started playing up.
Turns out, the E/F♯ key wasn't closing, requiring adjusting it's screw by a full turn!

As that was the only problem, I'm pleased!
 

Similar threads... or are they? Maybe not but they could be worth reading anyway 😀

Social

New! Social Feeds

Look out for the navigation icon:

Follow CafeSaxophone

Latest Song of the Month

Trending

Forum statistics

Topics
32,059
Messages
578,328
Members
8,127
Latest member
PJ2116
Back
Top Bottom