It's all brass there, every thing has the same coefficient of thermal expansion. You can thermal shock it for 50 years and there won't BE any thermal stress.
As square as that crack is to the edges, I wonder if the clamp was originally two pieces and brazed together? A failed seam could occur when tightening it due to bad substrate preparation or a cold joint.
At any rate, it needs to be fixed, because the clamp's no longer doing its job of mechanically fixing the bell-bow assy to the main tube. I already mentioned the ways this could create problems.
If the clamp can be removed without removing the bell-bow assembly, then I'd take it off, silver solder the crack, pollish it up, and reinstall. If the bell-bow assy has to come off, I'd separate it, clean the pookie off, and solder that joint; then you can repair the clamp and reinstall.
If you're all verklempt about losing lacquer finish on the clamp when it's repaired, you could TRY to find a replacement.
As square as that crack is to the edges, I wonder if the clamp was originally two pieces and brazed together? A failed seam could occur when tightening it due to bad substrate preparation or a cold joint.
At any rate, it needs to be fixed, because the clamp's no longer doing its job of mechanically fixing the bell-bow assy to the main tube. I already mentioned the ways this could create problems.
If the clamp can be removed without removing the bell-bow assembly, then I'd take it off, silver solder the crack, pollish it up, and reinstall. If the bell-bow assy has to come off, I'd separate it, clean the pookie off, and solder that joint; then you can repair the clamp and reinstall.
If you're all verklempt about losing lacquer finish on the clamp when it's repaired, you could TRY to find a replacement.
