Tech/maintenance Measuring octave pad stickiness.

The mucus and the watery fluid in spit comes from two different glands. In order of the mucus to watery fluid ratio these glands produce sweat, tears, eye fluid, spit, and mucos in different parts of the body. Most sweat doesn't contain mucus with the exception of sweat coming from mucosa tissue.

Some bacteria in the body produce other types of slime based on carbohydrates.

I regret giving this “experiment” the benefit of doubt that it had any relevance or credibility.

When attending/judging grade school science fair projects, it is often evident which projects try to actually make some effort at science. For the rest, it is often equally clear that they are first slinging something at the wall and then making up a story to placate their audience.
 
At practice today my f key stuck. I found myself in a fugue state (the dissociative kind).
I lost, nearly ten whole minutes thinking about pork rind fat,
also said application to cork. I was back in the room when my better half shouted
i had to pick the Grandkids up.
Dale
 
Not to rain on anyone's parade, but in my experience a pad is either "sticky" or it is not. After cleaning the pad and tonehole with naptha and rubbing teflon powder into the pores of the pad and blowing away the excess, it still makes a sticking sound it needs to be replaced. *

My way of checking if a pad is sticky or not is to put the end of the neck up to my ear like a stethoscope and open and close the key.

* Occasionally there is a burr around the top of the tonehole that makes the"sticking" sound after everything else has been ruled out.
 
I did a snot test. The performance test was inconclusive. Primarily due to the diameter of the 62 mm pad used. I don’t have the ability to compensate for the mass coefficient at 8.2 mm.
At approximately a angle of 42.5° a thin film layer was excreted. Normal surface temperature of 106°. The pad was made of drum tanned 2oz sheep skin. Woven wool felt and .030 cardboared back. No rivet as those tickle.


1693790245686.webp

After 7.1 hours the pad was removed. Breathing difficulties were hindering a longer duration for the test. As witnessed below some of the pad stuck on the surface. Approximately 10g of force was needed to remove the pad.
1693790012576.jpg



I hope this contribution is beneficial to your research:optimistic:
 
The tiny amount of mucus from test 8 produced a sticking power of 17,5 g. It is not fatal, but more than I expected. Around 35% of the baseline. It is a good reminder to clean your instrument after use.

test 9: baseline was increased by 7.5 g so the pad and the pip where cleaned and the baseline came down to the previous 50 g (test 10).
test 11 used a sugar solution of 2g per liter water with a sticking power of 10 g after 10 m.
test 12 sugar solution 2g/l 24 with 24 h waiting time is pending.
 
I regret giving this “experiment” the benefit of doubt that it had any relevance or credibility.

When attending/judging grade school science fair projects, it is often evident which projects try to actually make some effort at science. For the rest, it is often equally clear that they are first slinging something at the wall and then making up a story to placate their audience.
You seem to react on the style of an answer to a question not related to the test.

As a former reviewer of Elsevier scientific journals I don't believe that this review will pass any quality test.
You could improve your efforts by adding relevant facts and reasoning.
 
Not to rain on anyone's parade, but in my experience a pad is either "sticky" or it is not. After cleaning the pad and tonehole with naptha and rubbing teflon powder into the pores of the pad and blowing away the excess, it still makes a sticking sound it needs to be replaced. *

My way of checking if a pad is sticky or not is to put the end of the neck up to my ear like a stethoscope and open and close the key.

* Occasionally there is a burr around the top of the tonehole that makes the"sticking" sound after everything else has been ruled out.
If hides are too far gone before tanning the leather can contain small glue filled cavities. _It is indeed better to replace such pads.

The stickiness in this subject is mainly caused by bad cleaning habits.
 
I did a snot test. The performance test was inconclusive. Primarily due to the diameter of the 62 mm pad used. I don’t have the ability to compensate for the mass coefficient at 8.2 mm.
At approximately a angle of 42.5° a thin film layer was excreted. Normal surface temperature of 106°. The pad was made of drum tanned 2oz sheep skin. Woven wool felt and .030 cardboared back. No rivet as those tickle.
View attachment 23827
After 7.1 hours the pad was removed. Breathing difficulties were hindering a longer duration for the test. As witnessed below some of the pad stuck on the surface. Approximately 10g of force was needed to remove the pad.
View attachment 23826
I hope this contribution is beneficial to your research:optimistic:
Thank you for doing this. I hesitate to do such research as you have to fill in tons of forms for animal tests. Maybe the 2oz leather was on the thick side for this test, but yea, 62 mm pads are expensive. I hesitate to ask, but do you live near a zoo with chimps?
 
You seem to react on the style of an answer to a question not related to the test.

As a former reviewer of Elsevier scientific journals I don't believe that this review will pass any quality test.
You could improve your efforts by adding relevant facts and reasoning.

My mistake. I now realize that relevance and reasoning are not appropriate to this thread.

FWIW, I, too, am a former reviewer for Elsevier (and author), but my area of expertise is outside the scope of smearing goo on things to see if they stick.
 
Thank you for doing this. I hesitate to do such research as you have to fill in tons of forms for animal tests. Maybe the 2oz leather was on the thick side for this test, but yea, 62 mm pads are expensive. I hesitate to ask, but do you live near a zoo with chimps?
I agree, it takes twice the time to fill out the paperwork than doing the experiment. I used a 62mm pad instead of a 8 mm. concerned on getting stuck in a nostril.
Yes we did have chimpanzees at the LA zoo. They have been given a promotion. If you wish to speak to one of them call City Hall.
 
Yes, fantastic effort.

What personal protective clothing or apparatuses were used in the application of said pad?
I recommend:

• A laboratory coat, or other designated personal protective outerwear to be worn over street clothes, or designated clothing such as surgical scrubs or coveralls should be worn whenever entering an animal housing area or whenever animals are handled.

• Laboratory coats or other designated clothing such as coveralls or surgical scrubs should not be worn outside of the animal facility or laboratory and where possible should be laundered at the animal facility. If laundering at the facility is not possible, placing soiled clothing in a sealed plastic bag for transportation would reduce the exposure to allergens of persons outside of the animal facility. It is IACUC’s recommendation that a laundry service be utilized (may indeed be required in certain areas)

.• Wearing a dust/vapor mask and latex or nitrile gloves can minimize the risk of development of animal allergies and exposure to zoonotic diseases.

• Personal items such as but not limited to coats, backpacks, and hats should not betaken into animal-housing areas.• Shoe covers or rubber boots may be needed in areas where animal waste or potential pathogenic organisms may be carried from one animal area to another on foot wear

.• Wash hands with soap and water or decontaminate hands with an alcohol based hand rub after handling animals and before eating, applying cosmetic, smoking.

Reference:https://www.purdue.edu/ehps/rem/laboratory/Personal/PPE/ppe_index .htmlReference: For Animal Biosafety Level 2 studies, contact REM and IBC for information.
 
test12: 2g sugar solution 24 h gives a sticking power of 17.5g, 35% of the baseline.
test 13: the residual stickiness after test 12 is 7.5g.
Cleaning
test 14: baseline is 50 g
test 15: 20g sugar in 1l water gives a sticking power of 7.5g after 10m waiting.
test 16: 20g sugar in 1l water gives a sticking power of 22.5g after 24h waiting.
test 17: the residual stickiness after test 16 is 7.5g.
Cleaning
test 18: baseline 50g, but it needed much more cleaning than after test 13 to reach the baseline.
test 19: 100g sugar in 1l water gives a sticking power of 15g after 10m waiting.
test 20: 100g sugar in 1l water 24h waiting time is pending.

Writing errors in test 16 and 17 have been edited 17.5>22.5 and 76.5>7.5
 
Last edited:

Similar threads... or are they? Maybe not but they could be worth reading anyway 😀

Social

New! Social Feeds

Look out for the navigation icon:

Follow CafeSaxophone

Latest Song of the Month

Trending

Forum statistics

Topics
32,070
Messages
578,528
Members
8,132
Latest member
LouisJR
Back
Top Bottom