mpjbiker
Member
- Messages
- 240
- Location
- Hastings, East Sussex
Just come across an issue on my 66R-it has been on loan to my ex for a while, so not been used much. I've got a couple of gigs this weekend, so I thought I'd use it. I'd been having a blow at home, sussing out reeds and mouthpieces to use, finished and cleaned with pull through as usual. I picked it up a couple of hours later-could barely blow a note! I couldn't see anything obvious, so whizzed over to my tech to have a look. He popped a leak light down it, and said "oh.......". He looked at either the side Bb or side C pad and cup, and started levering. He passed it back and said "that'll play now, but be careful!". Apparently, the arm was coming unsoldered from the cup, and the pad/cup had moved enough to render the horn unplayable. It's a hard soldered joint, so hard to see that just manhandling it to clean could have caused the issue. Anyway, he's going to try and get it done in time, but says the finish on the key cup (antique vintage lacquer) will be ruined. Anyone else had problems with their 66R? Is it likely that other hard soldered joints are going to fail? It's affected my confidence in the horn, to be honest. My beater PanAmerican from around 1937 has not had these issues. Is it just one of those things?
