Tech/maintenance Mauriat 66R issue.

mpjbiker

Member
Messages
240
Location
Hastings, East Sussex
Just come across an issue on my 66R-it has been on loan to my ex for a while, so not been used much. I've got a couple of gigs this weekend, so I thought I'd use it. I'd been having a blow at home, sussing out reeds and mouthpieces to use, finished and cleaned with pull through as usual. I picked it up a couple of hours later-could barely blow a note! I couldn't see anything obvious, so whizzed over to my tech to have a look. He popped a leak light down it, and said "oh.......". He looked at either the side Bb or side C pad and cup, and started levering. He passed it back and said "that'll play now, but be careful!". Apparently, the arm was coming unsoldered from the cup, and the pad/cup had moved enough to render the horn unplayable. It's a hard soldered joint, so hard to see that just manhandling it to clean could have caused the issue. Anyway, he's going to try and get it done in time, but says the finish on the key cup (antique vintage lacquer) will be ruined. Anyone else had problems with their 66R? Is it likely that other hard soldered joints are going to fail? It's affected my confidence in the horn, to be honest. My beater PanAmerican from around 1937 has not had these issues. Is it just one of those things?
 
It's just one of those things - get it fixed and don't worry about it.
Mauriats may well have other build issues (as noted in my reviews) but flaky silver (hard) soldered joints have never been one of them.
Most likely scenario is that the key cup was poorly soldered and got passed over in the QC inspection - and recently copped a whack which tipped the joint into failure.
 
Just come across an issue on my 66R
There's a little bit of Café Sax magic. As I read @mpjbiker's post I came out in a cold sweat of anxiety; enough to match the distress of the situation
It's just one of those things
Then, (as I had secretly hoped), the soothing balm of experience, from one who knows, blew the baleful clouds of tension clean away
 
It's just one of those things - get it fixed and don't worry about it.
Mauriats may well have other build issues (as noted in my reviews) but flaky silver (hard) soldered joints have never been one of them.
Most likely scenario is that the key cup was poorly soldered and got passed over in the QC inspection - and recently copped a whack which tipped the joint into failure.
Very unusual circumstance. You have more eons more experience than I, but I’ve never run across a cup being loose from a key arm.
Maybe it’s my luck. After all, I do swing my rubber chicken over each instrument as it leaves the door.
 
It's rare - and usually something you'd see on an Ultra-Cheap horn rather than anything pricier.
A more common silver soldering fault is a bad joint where a key arm/foot meets the barrel. I suspect what happens is that after the joint is made and cools down, the residual flux (which is hard) gets mistaken for solder - and then the part gets chucked in the pickle/cleaner...and no-one really looks at it again.
 

Social

New! Social Feeds

Look out for the navigation icon:

Follow CafeSaxophone

Latest Song of the Month

Trending

Forum statistics

Topics
32,071
Messages
578,541
Members
8,132
Latest member
LouisJR
Back
Top Bottom