Misc electronics All things in the battery powered microphone, mixer and speaker sphere.

FWIW... I echo everything that's been said above about keeping it light and maneuverable. I recently published the second edition of my Solo Sax Gig Handbook (see attached), based upon my experiences and lessons learned at nearly 800 solo gigs over the past 10 years -- ranging in audience sizes from a half-dozen to 300+. The Handbook has a detailed section about equipment, including photos of how I set up for different types of gigs. I'm a Bose-o-phile, so I've been using the S1 Pro units extensively -- and sometimes the larger L1 Pro 8 line array unit -- over the past 6 years with much success -- but there are plenty of other lightweight options that are good as well.

Yes, today's battery-powered lightweight units punch well above their weight. I've played gigs of up to 200 people with just two Bose S1 Pro units, with no complaints about lack of volume. I've also played a gig for 325 people with just the Bose L1 Pro 8 (not battery powered, but I carry a small 250w power supply with me to power it for 4+ hours in case I'm not near an outlet). It was a 9000 sf room, so things were kind of tight with that many people (no room to stroll).

One thing I've noticed... It's not so much the number of people that'll dictate the size of the sound system you need -- but rather, the size of the room. Last week, I played for the Disabled American Veterans Auxiliary Luncheon at a big hotel in Orlando... Only 200 people, but the room was 15,000 sf and could've swallowed 300 people with room to spare. I used my L1 Pro 8 next to the stage (ran it on my portable battery pack because there was no outlet nearby), along with two S1 Pro units (each about 50 feet away from me). (See photo below). PLENTY of power to fill the entire room with my sax, tracks, and vocals -- at just 50% volume -- for pleasant background music evenly dispersed while the attendees ate. Did a lot of strolling with my wireless sax and vocal mics, with no dropouts. Also did some patriotic sing-a-longs after the speeches. Best part? The venue had set up FOUR QSC 12-inch powered speakers along the back of the room beforehand, with a wireless handheld microphone at the podium on the stage next to me -- for the luncheon speakers to use. Yet -- after listening to my sax/vocals as they were arriving, they liked the clarity of my system so much better than the house system -- that they used my wireless vocals mic for their speeches. Oh, and they booked me for their mid-winter conference in January before the gig was over.

I hauled everything from my car to the room in one trip. As always, I used my rolling Gard double sax bag for my tenor and soprano, and all the sound gear, miscellaneous equipment -- and spare tenor -- fit into a 48" collapsible wagon.

The technology keeps getting better and better.

Fred

DAV-3Aug26-12-1.webp
 

Attachments

Having some dependable gear can be handy. Restauranteur called me last minute for a solo gig.

His sound system went bad. Powered column PA to the rescue. 🙂

Set it up, connected his tablet to provide music for staff and patrons the day before the gig and just connected my mic and tablet for tracks the night of the gig.

I’ve got gigs every weekend for the next 3 weeks but won’t need it until the 8th so works out great for everyone. 😎
 
Last edited:
I did a gig at a yacht club the other day and had interference on my microphone it was getting static at fifty feet out. I use UHF broadcasting and I had this happen before at a marina. It can't be caused by closeness to the water as I have done wedding and parties at cottages and lake front parks. Is it possible it is due the the boats all having GPS, and shortwave plus tall aluminium masts? I got through it but a real pain.
My speakers were okay broadcasting UHF and I had one setup outside on the patio overlooking the lake.

I put it to my Chinese UHF sax mic so I ordered this unit yesterday. It should eliminate any future problems. It claims it can broadcast 150 meters! 🤯
1787076343257.webp

 
Last edited:
Good question- my current broadcast mic system was cheap I think $80.00 CDN and I no longer have the specs sheet and there was never any reviews of it on line. But I think it was in the 470 to 600 range. So it may be in the boat broadcast range or close.

I will post the specs on the new one when received if more detailed specs included. I will continue to use my current unit just keep it for back up if the new unit does the job.
New unit is bulkier and not sure about the bell clamp but we will see. The thing is almost it's own broadcast station at 150 meters.

Here are boats frequencies.
Appears I recalled correctly. Looked it up the Chinese frequency range s used in North America.
Popular Chinese brands sold on Amazon, like Phenyx Pro, XIAOKOA, Kimafun, and Baxpro, modify their frequencies to adhere strictly to local laws. Mine is a BAXPRO model.
  • Frequency Range: Typically 500 MHz to 599 MHz (e.g., 520–580 MHz or 538–566 MHz).
  • Legality: 100% Legal. This fits perfectly inside the safe 470–608 MHz terrestrial broadcast spectrum, keeping you away from restricted cellular networks.
Here are boats frequencies.
UHF Range Breakdown on Water
  • Bow-to-Stern / On-Board (Internal Systems): Unlimited on-board coverage. Large commercial vessels, cruise ships, and superyachts use UHF radios (typically 450–470 MHz) because the shorter UHF wavelengths bounce cleanly through metal corridors, decks, and engine rooms where standard VHF signals get trapped.
  • Handheld FRS/GMRS Walkie-Talkies: 1 to 3 kilometres (0.5 to 2 miles). Boaters frequently use consumer UHF walkie-talkies (operating in the 462–467 MHz band) to talk to family on the beach, tenders, or other boats nearby. While manufacturers print "30-mile range" on the box, the flat curvature of the water blocks the signal past a couple of kilometres unless you are standing on a high flybridge.
 
The Bose 2.4 GHZ is better and faster than Bluetooth but only good to a max of 30 feet / 9 meters and gets blocked by pillars and such even a dense crowd. I used 2.4 before going UHF. I am doing fields and large convention halls. It works well and is dependable but I connected my speakers with UHF and then moved to the mic.

Gotta be the big yachts.
 
Part of why I love my CloudVocal setup is the stable 2.4ghz connection. They utilize some kind of frequency hopping algorithm that has only failed me once.

That was a gig where I had the receiver sitting on the floor and I was about 50 feet from the receiver with a mass of bodies on the dance floor between me and the unit. Experienced dropout during that excursion.

Turns out water absorbs 2.4 signals and people are largely ahh… water. 🙂 Even proximity to large bodies of water can reduce your effective range.

After checking with CloudVocal they said that mounting the receiver higher is helpful.

Ever since that event - no issues.

In any event I’m always belt and suspenders. I bring the Prime and an Evno Air SX (900mhz) just in case.
With the Prime I don’t need effects. With the Evno I either rely on the soundman or I have to bring my effects box.

Key learnings for me:

Cloudvocal - mount the receiver off of the floor. NUX - mount the receiver or transmitter away from the board - even with a 5.8ghz unit.
 

​

lig you are correct dang! I checked and in far mode it can broadcast 15 to 30 meters!​


However at a cost.

1787098091903.webp

🤔 In hindsight and upon review I may return the unit I just bought and bite the bullet and upgrade to a premium system like yours. One tends to get what you pay for with quality gear. The Chinese stuff is disposable thus cheap. But 150 meters broadcast is so tempting yet rarely if ever needed. The mic will not compare as well.
 

​

lig you are correct dang! I checked and in far mode it can broad cast 15 to 30 meters!​


However at a cost.

View attachment 36614
🤔 In hindsight and upon review I may return the unit I just bought and bite the bullet and upgrade to a premium system like yours. One tends to get what you pay for with quality gear. The Chinese stuff is disposable thus cheap. But 150 meters broadcast is so tempting yet rarely if ever needed. The mic will not compare as well.
The team from Cloudvocal are some clever Taiwanese fellows and I do trust them a good deal more than the lower cost Chinese makers.

The Prime has done right by me for over 5 years and counting now. I only use it near mode. I think they mentioned there may be a slight sound quality penalty in Distance mode.
 
.... mounting the receiver higher is helpful.
I was going to say - in, for example, the venue above - thinking about external antenne on top of the speakers, and such, would clear the meat obstacles.

Not all antenne are created equal for all frequencies - so it takes a bit of working out.
 
Max output of most radio mic is about 50mW signal strength decreases with distance. Also signal recieved is probably, at most , 1 360th of that as that signal will be a circular pattern and at the angular spread is may be 1⁰ at at the reciever.
Edit The sax is a huge chunk of metal and will absorb and distort the signal.
 
I did a gig at a yacht club the other day and had interference on my microphone it was getting static at fifty feet out. I use UHF broadcasting and I had this happen before at a marina. It can't be caused by closeness to the water as I have done wedding and parties at cottages and lake front parks. Is it possible it is due the the boats all having GPS, and shortwave plus tall aluminium masts? I got through it but a real pain.
My speakers were okay broadcasting UHF and I had one setup outside on the patio overlooking the lake.

I put it to my Chinese UHF sax mic so I ordered this unit yesterday. It should eliminate any future problems. It claims it can broadcast 150 meters! 🤯
View attachment 36608
I have not been to the yacht club again but the new mic kicks serious butt! A bonus is I can adjust the volume with it while on the floor or stage so a better sound scape for the clients.
Excellent broadcast over large distances with large crowds and pillars blocking the signal . No drops no problems. Saw the same unit for $450.00 so a steal at the clearance price.
UHF rocks! 🤘🏽

I did encounter a delay on my system, ruled out the mic by switching it out. Mucked with the Roland Go mixer to no avail trying different ports and cables. Spoke with the engineers at ECOGEAR looking for help.
The problem was the speaker automaticity boots up in the ECOGEAR Bluetooth ecosystem which caused a signal routing delay.
Easy fix is to just shut of the Bluetooth button when powering up the speaker.
Delay is gone!

I find it hard to believe I can have a coherent conversation with an electronics specialist considering where I was knowledge wise three years ago. I spoke with Roland’s technical staff and they were not much help. Suggested it was my feed from the iPad to the mixer, possible bad cable and or data compression.😎

Met with my Dad today made a few adjustment to my new stand system. He will make the requested mods and the plan is I will use it this weekend. Will post pics and results.🤞🏼
 
When the guitarist in the "woodsheed band" bought a new amp we got an extra "click" when we were playing. It was the wireless system that picked up the signal from the fence. The neigbor have a electric fence to keep out wild bour from the cow pasture. A rainy or a foggy day the signal was stronger. I don't use wireless systems. I'm a grounded person.
 

Social

New! Social Feeds

Look out for the navigation icon:

Follow CafeSaxophone

Latest Song of the Month

Trending

Forum statistics

Topics
32,058
Messages
578,304
Members
8,127
Latest member
PJ2116
Back
Top Bottom