Chris98
Senior Member
- Messages
- 1,135
Hi Chris, I guess for a first attempt at recording with a backing track it wasn't too bad, although its sounding worse and worse to me as I get better! There was no reverb or anything added to the recording, it was just an MP3 track and then my mic recording of the Sax. I'm not really too worried about adding any effects just yet, I'm mainly using the mic so I can listen to all my flaws and try and improve on them.
The Sax was very close to the microphone when I recorded that, probably too close, but I've got a bit more used to it now and moved further back, I've just increased the gain on the mic to compensate.
One think to note about the mic I'm using regarding monitoring... the sound that comes through the headphones from the mic is actually directly from the mic rather than going to the computer and then back to the mic, this pretty much eliminates the lag completely regarding what goes into the mic.
Hi Jason,
That's quite a neat mic you've got there, I've just downloaded the manual. Shure look to have overcome the issues I was worried about. (Not sure they were worth worrying about in the first place but until you get to play with something you never know.)
I love the marketing, that description is the same for nearly all large diaphragm mics!The PG27-USB large diaphragm side-address condenser microphone features a neutral frequency response and low-self noise for faithful reproduction of a wide variety of sound sources—from piano and wind instruments to drum overheads, acoustic guitars, and vocals.
As you said, the variable gain stage pre-amp is prior to the analogue to digital converter and that's exactly where you'd want it. Monitoring is direct and by the sounds of it analogue with a blend control, again another thumbs up.
The only limitations are that you are probably limited to 3-5m cable length without a repeater and a 48kHz top sample rate, but when you consider CDs are at 44.1kHz your already doing a bit better. Having said that, if you're playing along with a CD I'd set it to 44.1kHz.
I hope you post more recordings as you do them.
With regard to reverb, it's a subjective thing and easy to be a bit heavy handed with it, or maybe that's just me. Anyway if you are close mic-ing you will be reducing the natural reverb of the room that's recorded as well, so it might sound a touch dry. Also the backing track will most likely have been mastered with a bit of reverb and if you want to sax it sit in the mix a bit better, adding reverb to the track can help.
Best wishes,
Chris

:welldone