Welcome to the Café!Let's put this thread on hold until next week, shall we? It is off the rails.
Smallest thing I have for a job like that is an engraving tool for a Black and Decker Wizard.What the world needs is a teeny little electric needle scaler. Are there any tools for the oscillating multi tool that could serve?
Not that I know of. The ones that I’ve used were 1” diameter of 1/32 or 1/16” rods.What the world needs is a teeny little electric needle scaler. Are there any tools for the oscillating multi tool that could serve?
Not really. If you had a tiny little needle scaler you could chip that stuff out without having to do it manually. I wonder if a vibratory engraver with the tip of the bit ground flat would work.Let's put this thread on hold until next week, shall we? It is off the rails.
N95s are good for particles but not vapors.Thanks for pointing out the hazards. I have a box of N95’s on my bench. Always masked until assembling.
It’s my understanding the unit has retained the original finish. Cosmetic condition excellent. How would you go about blasting with any medium ?
Like ether...Also keep in mind that butane is heavier than air
Oh, please don’t do that.MAKE IT STOP!
Must I turn off notifications?
Yes, that or "unwatching"§ the thread will freeze the notifications.MAKE IT STOP!
Must I turn off notifications?
I already did. I will be back next week.Oh, please don’t do that.
That will be tomorrow then?I already did. I will be back next week.
Thanks for that idea - I have one of these, and there are lots of them cheap on ebay. I wonder if I'll remember this conversation if and when I need it for this purpose! https://www.ebay.co.uk/itm/900072831631Not really. If you had a tiny little needle scaler you could chip that stuff out without having to do it manually. I wonder if a vibratory engraver with the tip of the bit ground flat would work.
I agree. Still there’s 24 cups to do. Then any residual to clean off. At that point maybe the acetone would help ?A chisel shape would be best,
