- Messages
- 12,967
- Location
- KIC 8462852
That is why I said warm not heat, if you can hold it then synthetics shouldn't be melting.I'd caution against this. The pull through
could have synthetic materials in it that might melt making the problem a whole lot worse.
The best thing you can do is take everything to a tech as others have advised. Where are you located?
Maybe use warm water instead of the dryer and don't get the cork wet.

I'm not sure why I wasn't able to do it before, must not have had the right bending technique. It was simple once I figured out how. Thanks so much guys for your help
I'm going to have a go tonight to make sure it plays ok as I only did a quick test, but the lower octave is now working so fingers crossed it's sorted now.