Stephen Howard
Well-Known Member
You could always rounding off the tip of the drill a little (just take a little of the edge off with a sharpening stone). Might allow the drill to progress into the bore a little easier. Don't think you have much to lose at this point.With the drill bit held in a vice I got enough purchase to twist the mouthpiece off.
I have since been trying to use that setup to remove more material but although quite a lot has been removed the drill only wants to go about one inch into the bore. I have been backing it out and cleaning off the ebonite pieces but think this is not the way to go so may leave it alone now.
Thanks for the help.
Rhys (a rookie)
What you really need for the job is a reamer...and drills tend to make crappy reamers.

