Tech/maintenance Mouth piece patch trouble

eb424

Well-Known Member
Messages
4,216
Location
london
Hi i have a metal lebayle mouthpiece and the beak is slightly curved. I cannot get a mouthpiece patch to stick. Would glue do the job? If so what could I use? clean it first with lighter fluid but none of the patches i have will stay on..
 
Last edited by a moderator:
Hi i have a metal labayle mouthpiece andvthe beak is slightly curved. I cannot get a mouthpiece patch to stick would glue do the job. If so what coud i use..I clean it first with lighter fluid but none of the patches i have will stay on..
Wotcha, Bri

Did you clean the mouthpiece before you applied the patch? Oh you did but it didn't work, so try soap and water. On metal you can use any solvent...meths, acetone, whatever

If the mouthpiece was squeaky clean the patch is at fault

Ditch whatever patches you have and try a different variety

Some patches slip down the beak over a few weeks, but others stay put
 
Vote:
Upvote 0
Not all glues are created equal, different solvents will deal with different glues; and some solvents will leave a residue. So try other stuff; and then soap and water.


Googling that, some have built-in patches... Does / did yours?
No might phone Ed and see if he can put1 on...Troule is it is so cold in the caravan and being a metalpiece..I don't know if it will do any harm but I stuck it in the drawer above the heater with the patch and then stuck it on and left it in there..heres hoping...heard that glue may help non toxic rubber glu but dont know if this is just for ebonite pieces..
 
Vote:
Upvote 0
.cold cant help
Actually, I suspect too warm is worse then too cold. But "body temperature" should be fine as that's what a patches operating temp should be!

Good clean and airing cupboard before I go back in the van
We don't need to know your personal hygiene regime!
 
Vote:
Upvote 0
Eb, technically yes, a bite plate can be added to the piece. Practically, I dont think you will want to pay for it and I dont know anyone who does that sort of work.
 
Vote:
Upvote 0
Cleaning for adhesives is best done with a solvent that is NOT oil-based. Lighter fluid is oil-based. Few pressure sensitive adhesives work well on surfaces with an oily residue. Clean the mouthpiece with alcohol. Make sure it's completely evaporated. Peel the patch from its backing with a clean knife or something similar, not your oily fingers. Place it, then (this is important) use something rounded to rub it down till it's in excellent contact over its entire area.
 
Vote:
Upvote 0
Cleaning for adhesives is best done with a solvent that is NOT oil-based. Lighter fluid is oil-based. Few pressure sensitive adhesives work well on surfaces with an oily residue. Clean the mouthpiece with alcohol. Make sure it's completely evaporated. Peel the patch from its backing with a clean knife or something similar, not your oily fingers. Place it, then (this is important) use something rounded to rub it down till it's in excellent contact over its entire area.
Lasr one stuck well but 30 mins of playing in the cold and off it popped. Would a small piece of gorilla tape first help..
 
Vote:
Upvote 0

Similar threads... or are they? Maybe not but they could be worth reading anyway 😀

Social

New! Social Feeds

Look out for the navigation icon:

Follow CafeSaxophone

Latest Song of the Month

Trending

Forum statistics

Topics
32,073
Messages
578,626
Members
8,133
Latest member
walthang
Back
Top Bottom