Tech/maintenance ?Loss of air on low D / onwards....

Messages
72
Location
Barnstaple
Dear All,

my lovely Yamaha YTS-22 had a service at JohnPacker roughly 6 weeks ago. Very kind people, good service as played much nicer afterwards, easier blowing, and also much easier to get low Bb / low C. I actually managed to progress and get the low notes and overtones more regularly and consistently. I always play, clean, and put the sax back into its case so no dinging / falling.

Why I'm reaching out is that today when playing scales from top down when reaching low D it feels that there is a loss of air / sudden drop in pitch / clarity. (I know low D can be stuffy but this is new....). Also, I am struggling / flat out not managing getting low C and Bb out as first note. when playing / jumping from other notes it still works. I'm still just over 18months into learning to play but I had practiced the low register and intervals coming from C / Bb hard recenently and it worked. Something has changed suddenly and I'd like to figure out what. John Packer are 70min by car away so worst case I'll drop by there but am rather busy and could do without the trip.

Any ideas?

As always. many thanks for your time and help.

Cheers,

J.
 
I don't know anything other than my YTS23 ...
But if that happens on it...
There's a bar on the other side of the bell, that D, E and F push up for Bb, G#, making coffee etc. There's a tiny regulation screw for each key that adjusts lifting that bar. If a screw is too high, the mechanisms won't work, if it's to low it can stop the key closing. Also there are leavers higher up that can do the same.

BUT it's tough to adjust without a good watchmakers screwdriver and a leak light.

And it might be something else!

A leak light is the tool you'd need to diagnose it, I'd guess
 
If it feels like a vacuum cleaner sucking your air out on low D it's a leak someplace.

Indeed could be a regulation leak in which case the F# bench adjusting screws need to be readjusted.

But it's not a home DIY for a novice sax troubleshooter with no leak light.

Take it back to the tech, tell them something's up. I doubt it's you since you said initially after service everything was peachy.
 
I’m not exactly sure what you mean…..
I'm not sure if a YTS-22 have detachable body-bow? A YTS 21 in Sweden have detachable body-bow. The part with two screws that connect the body to bow. Yamaha dropped the detachable body-bow on the YTS 23. Must be a reason?
 
Dear All, the YTS-22 is essentially a 21 that was made in Japan for the Japanese market as far as I understand it.

I had a play and found that the G# was moving a bit when playing B / Bb and maybe also low C key. The little rod with the felty cork thing that seems to be designed to keep it down when playing was turned a bit and didn't connect fully (sorry for my warped and inaccurate terminology). Much better than before...... not perfect but much better...
just read a post from another thread to finger Bis with a right hand when pressing all there left hand fingers down and see what moves. Will try that later.

I also seem to remember about a regulating the D pad... will check in SH's book. Then off to the tech if that doesn't solve it completely. I just hope to not have to do the drive and potentially leave it and pick it up another day after yet another drive....
 
Dear All, the YTS-22 is essentially a 21 that was made in Japan for the Japanese market as far as I understand it.

I had a play and found that the G# was moving a bit when playing B / Bb and maybe also low C key. The little rod with the felty cork thing that seems to be designed to keep it down when playing was turned a bit and didn't connect fully (sorry for my warped and inaccurate terminology). Much better than before...... not perfect but much better...
just read a post from another thread to finger Bis with a right hand when pressing all there left hand fingers down and see what moves. Will try that later.

I also seem to remember about a regulating the D pad... will check in SH's book. Then off to the tech if that doesn't solve it completely. I just hope to not have to do the drive and potentially leave it and pick it up another day after yet another drive....
I was going to suggest checking that spot. It's where three keys / cups are interacting with each other and it is easy to mess things up if you are not very careful. But the easy check is to have somebody hold the G# close while you are playing and see if that solves the issue, if yes, you know pretty much what needs to be adjusted and you either tell your tech or you figure it out yourself. But, if you "tighten" that little rod too much, the key that it is attached to won't close anymore and you just shift your problem to another spot.
 
We have an article on low note problems caused by the G# tab linkage or articulated G#


I have to say in this case you mention C and D as having issues. With the G# thing it affects Bb B and C# - but could easily be combination that issue and something else.

If the bell got knocked ever so slightly out of whack could affect the low notes. Mentioned previously can easily happen when slinging a shoulder strap case on.

Having said all that a leak anywhere can affect ct low notes.
 
Dear All, the YTS-22 is essentially a 21 that was made in Japan for the Japanese market as far as I understand it.

I had a play and found that the G# was moving a bit when playing B / Bb and maybe also low C key. The little rod with the felty cork thing that seems to be designed to keep it down when playing was turned a bit and didn't connect fully (sorry for my warped and inaccurate terminology). Much better than before...... not perfect but much better...
just read a post from another thread to finger Bis with a right hand when pressing all there left hand fingers down and see what moves. Will try that later.

I also seem to remember about a regulating the D pad... will check in SH's book. Then off to the tech if that doesn't solve it completely. I just hope to not have to do the drive and potentially leave it and pick it up another day after yet another drive....
Finger F & hold (don’t squeeze). Press G# while looking at the G# keycup. The G# keycup shouldn’t move / lift. Same test, do E, D. Then FED and hit Bb. No sequence should lift G#.
If you model has the adjustment screw below and you have a proper screwdriver…..
1729927017497.webp
 

Similar threads... or are they? Maybe not but they could be worth reading anyway 😀

Social

New! Social Feeds

Look out for the navigation icon:

Follow CafeSaxophone

Latest Song of the Month

Trending

Forum statistics

Topics
32,064
Messages
578,440
Members
8,130
Latest member
tommyliehe
Back
Top Bottom