Tech/maintenance Hell in a caravan....sticky pads

eb424

Well-Known Member
Messages
4,216
Location
london
Morning all, I play in my caravan and am having a torrid time with sticking pads whilst playing...I use a sax snake after playing and always leave the sax out to dry after swabbing after practice....when first playing the pads are fine but after a while the C# G# and D# start sticking...I used yam powder paper last time after cleaning with lighter fluid and kept the door shut whih helped a bit...I play a YTS custom z and think Yam pads are a little stickier than any other this may or may not be the case...does anyone here know if there are less sticky pads that I can swap the 3 notes above for that would mix with the current set.....
 
Last edited by a moderator:
Key Leaves and leaks ... that was my thought as well. I think a closed pad should be closed most of the time.

I think it's better to use key bumpers and key felt under the key arms to vent the tonehole and the pad. Eb, G#. side Bb and C. Palm keys use some kind of wedges. C# is trick y on my Martin. But low C# is not often stycky. Small pieces of cork is also fine. If you leave a closed key open often and for long time, what happens to the spring? Leaks?

Keybumper under G# keyarm.
keybumperg#.JPG

Keybumper under Eb keyarm.
keybumpers eb.JPG

Rubber wedges between palm key arm and body.
gkilar.JPG
 
Vote:
Upvote 0
Key Leaves and leaks ... that was my thought as well. I think a closed pad should be closed most of the time.

I think it's better to use key bumpers and key felt under the key arms to vent the tonehole and the pad. Eb, G#. side Bb and C. Palm keys use some kind of wedges. C# is trick y on my Martin. But low C# is not often stycky. Small pieces of cork is also fine. If you leave a closed key open often and for long time, what happens to the spring? Leaks?

Keybumper under G# keyarm.
View attachment 20566
Keybumper under Eb keyarm.
View attachment 20567
Rubber wedges between palm key arm and body.
View attachment 20568
Key leaves ( or the cheapef ones on ebay £6) are like cheese wedges you can hold the pads open as wide or tight as you like. Also for just as long as it takes the pad to dry...I take one in the van and if ( when ) i stop for a ciggie and beer break no issues...
 
Vote:
Upvote 0
Morning... I read on another forum a way to get rid of sticky pads was to use 1200 wet and dry with lighter fluid. Use the paper side up..is this likely to gradually file down the tone hole..Also my sax stays in the caravan which is now cold..I use 4xs key leaves after playing to keep normally closed keys open. This means the sax is on its stand. Would it be less condensatey ( probably not a word lol) if i left it in its box . Any opinions??
 
Vote:
Upvote 0
If you use anything abrasive on your toneholes, yes, it will file them down...eventually. But with 1200 grit you'll be a very, very long time getting there. I really wouldn't worry about it.
As for the condensation, the horn will be better off in its case - though ideally it should be dry before you put it away. Probably not possible at this time of year, but it's definitely the lesser of two evils.
If you have mains power it might be worth going for a 40watt tubular heater. I use one in the workshop, under the lathe (with a cloth cover over it), to keep moisture from forming on the chuck and lathe bed.
 
Vote:
Upvote 0
Heating and ventilation. Do you have condensation on you sax even when you are not blowing? Is it hard to find practice places/rooms in London? A friend sold his his car and built two practice rooms (2 x 4 m/room) in his garage. Many wind instrument players that need a place to practice. No big business but so far the rooms cover the costs,
 
Vote:
Upvote 0
I've just had my Zephyr serviced. The G# key was very irregular and and weak in its response. I was certain that it was a mechanical issue but it turned out that it was sticking just enough to cause it to hesitate. I had no indication of that happening as I felt no resistance. The good ol' 1200 grit paper did the trick and it works great, now.
 
Vote:
Upvote 0
I've just had my Zephyr serviced. The G# key was very irregular and and weak in its response. I was certain that it was a mechanical issue but it turned out that it was sticking just enough to cause it to hesitate. I had no indication of that happening as I felt no resistance. The good ol' 1200 grit paper did the trick and it works great, now.
You could similarly just use a cotton bud and some naptha to clean the tone hole and pad.
 
Vote:
Upvote 0

Similar threads... or are they? Maybe not but they could be worth reading anyway 😀

Social

New! Social Feeds

Look out for the navigation icon:

Follow CafeSaxophone

Latest Song of the Month

Trending

Forum statistics

Topics
32,071
Messages
578,556
Members
8,133
Latest member
walthang
Back
Top Bottom