Saxophones Conn Caravelle

@Colin the Bear - WARNING!!

I had a horn shipped to me in a Berkeley case. Arrived with 17 dents it didn't have when despatched.

Ask the sender to wrap it well inside the case. They must be the worst designed cases ever made.
Agreed. An outer shell which isn't even that strong, but the real problem is a lack of shaped padding to hold the sax secure. Less protection that the zippered, polystyrene-based cases you get with a super cheap sax.
 
It has arrived. It had been shipped before I could act on your warnings.
Being a frequent seller with a good reputation I assumed the packing would be efficient.
It wasn't. The case was very well boxed but nothing in the case.
On close inspection all I can find is a bent C key guard and a bent Eb key guard that has pushed a small dent into the tube.
Otherwise it's very good. It needs a clean and a bit of regulating cork here and there. I've had the leak light down and everything is tight. The pads look like they've been replaced at some time.
It plays top to bottom with a sweet, polite tone.
I can see what you were saying about the case. If I'm going to take it out, I will have to replace it.
Credit to Martin for building a tough horn that's survived nearly a century.
The action is tight and rattle free.
No front F but G/G# and D/D# trills.
Ergonomically it will take some getting used to but I expected that.
My vintage gas has passed. 🙂
 
Sounds like you just about got away with it, @Colin the Bear A couple of bent key gards and a small dent isn't too bad. Now, how many altos is that you've got?
 
Nine...I think. Two for repair. One for sentimental reasons. Two bought to try and sell on. One pig in a poke. Three to play. (Jap Chink Yank). I'd better stop now. I don't thin

Agreed £190. Went to pick it up today. They can't find it. Lot's of excuses An 80 mile round trip for nothing. I suspect they've had a better offer.
Johnny Roadhouse. No stars. :rolleyes:

Interesting little shop. You can hardly move for string things. Guitars, basses, ukeleles, banjos, mandolins, dulcimers and many strange and wonderful stringed instruments that I couldn't pronounce and haven't seen before. Drums in the basement.
A small selection of second hand saxophones. Saw a mint YTS475? for £1100. Had a blow while they looked for the caravelle. It didn't like my S80 at all and had a warble with the soloist. Not much umph. I suspected a leak.
Left the shop a bit miffed.
The hunt goes on. 🙂
Ive got it, the weird and wonderful world of blowaneza
scrooge,... Pads arnt that bad and he chucked in a mouthpiece and a reed. I mentioned you and it was a genuine case of miscommunication from what I can gather and the folk in the shop didnt know where it was. I didnt mention the relisting but you said it was a carpet that was relisted.
 
So to wrap this up Johnny roadhouse is genuine, good communication on ebay and I had a bargain with the mexiconn caravelle. He also chucked in a mouthpiece and reed to get me going.
 
I will send some, just had the bottom end off up to The G key, cleaned rods, twanged springs, bent a couple of keys and used some sticky backed greenhouse foam for a couple of temporary shims. Then put it back together, it needs pads so it was a dummy run. Seems simple enough. The plan is repad it then take it to a sax tech to set her up. Been studying repair vids the last 2 days the problem people seem to run into is getting the pad level in the cup.
Ive been thinking of making moulds out of modeling clay for the cups then theres something to press against whilst the shellac sets.
Never used shellac, never replaced a pad before but Im encouraged by the dummy run and will forge ahead once Ive bought some pads. Shes got the tone Im after, all good.
Drove meself nuts trying to find what it is because of conn myth and history. I reckon its a meccano sax cos stocks of parts were low when its dated. Left Bell B and Bflat, ski/ curved top E, its not new wonder keywork as some say but theres bound to be some similarities.
Its got the selmer wobble bar octave mechanism the wonders a two spring affair and the pinky plates are different Ive got the 9 iron pinky plate which I need because of a half numb pinky finger. ( easier for me to plop out a low Bb) top side keys are closer to the body than the last 16m stencil I had which was branded a blessing with keys all down the right hand side.
First project and theres a bonding thing going on.👍
 
Im mot saying anyones right or wrong about conn history, its a mess but this ones deffo a mish mash of different parts to the conn blessing and a couple of directors Ive owned.
 

Similar threads... or are they? Maybe not but they could be worth reading anyway 😀

Social

New! Social Feeds

Look out for the navigation icon:

Follow CafeSaxophone

Latest Song of the Month

Trending

Forum statistics

Topics
32,063
Messages
578,427
Members
8,129
Latest member
Bartman
Back
Top Bottom