Tech/maintenance What do the left hand table fulcrum screws adjust?

Messages
700
Location
USA
I don't know if I'm using the correct terms here, which might be why my searching on this topic isn't getting results. Or maybe this is so basic no one asks. Could someone tell me what the three screws at the top of the LH table fulcrum adjust (if anything)? Or do they just help hold the low Bb, B and C# keys on?

I ask because I noticed that the screw at the top of the rod connected to the C# table key was out of its hole a few mm. I went ahead and screwed it back in but I'm wondering if it was like that on purpose (I haven't noticed much difference before/after adjusting that screw).

PXL_20240722_163339607.webp
 
A screw or rod working lose once is unfortunate.
If it works lose twice, maybe a trip to the Tec?

And, don't over tighten it if its a pivot it's not holding anything anything down.
 
Last edited:
1721710596850.webp

Hinge rods
Pivot screw(s)
They can back out (unscrew) from lack of lubercation.
This is a sign your sax is way past due for service. Oil change/ service should be done annually with spot oiling done periodically between service. Premature ware often occurs from lack of service.
Take your horn to a technician for a COA service. Clean-oil-Adjust. You’ll be happy you did.
 
They hold the rods in place.

They ARE the rods. If you follow the tube to its other end, you'll see a slightly smaller 'screw end'
that's the threaded bit that holds them in place. I hear the new fantsy saxes have some adjustment screws like flutes and such,
but traditionally, all saxophone adjustments are done with shims and bending. And sometimes a hammer.

t
 

Social

New! Social Feeds

Look out for the navigation icon:

Follow CafeSaxophone

Latest Song of the Month

Trending

Forum statistics

Topics
32,064
Messages
578,455
Members
8,130
Latest member
tommyliehe
Back
Top Bottom