Tech/maintenance Sticky pearl keys on Saxophone.

Stop drinking it womt help....lol..I had the same probley with my 82z..had the spring tightened on the b and Bb it helped..im also swapping gradually to roo pads..I use 1200 grit wet and dry rough side down to clean the toneholes too..
 
Are the keys sticking or are the pearls themselves sticky? Not clear from your post.

If it’s the pads getting stuck to the tone holes, then the best cleaner is naptha. Not alcohol, that won’t do the job. Put some on a q-tip, wipe the pad seat, and also the top of the tonehole. Then wipe with a clean q-tip. (q-tip in Nevada = cotton bud in the UK.)

If you can’t get naptha at the hardware store, then use lighter fluid from the local smoke shop. (In California, this is the case.) More expensive, but you only need a little.
 
Are they actually pearls, or just plastic? If plastic, consider replacing them. I found some cut stone “pearls” on EBay for about $10 a set, and put them on a cheap soprano. They feel great.

I use to live in Lake Tahoe, and played in Reno, so I am familiar with your area. I never experienced this phenomenon. I would replace the pearls.

BTW, if they are really mother-of-pearl, I would try naptha on them too 🙂. It might be lacquer on the pearls, so could carefully remove that with acetone on a q-tip. Just don’t get the acetone on the rest of the horn.
 
Some people really sweat profusely even on their fingers. Not sure whether that might be the issue and if it is, there is not much you can do.
On the other hand, there are some really cheap plastic pears that get sticky if you look at them. Like @skeller047 said, a set of replacement abalone or mother of pearl is pretty inexpensive on Amazon but make sure you know the diameter you need, I replaced everything on a soprano and ended up buying 4 sets because each one only had one of the 4 that I needed to replace. Still, $40.- total isn't a big deal if it solves the problem.
 
If the pearls are plastic then they could be suffering from SPS (sticky plastic syndrome). It’s actually a thing that can happen to some types of plastics, inc TV remotes. My JBL studio monitors got this after a few years. Detergent, lighter fuel, meths, nothing worked until I contacted JBL who admitted the fault and replaced them

However the replacements are now getting a bit sticky and I found some people recommend the product Goo Gone. However I happened to have a bottle of Acetone lying around, as you do, and it worked beautifully. Whether it would work in this case there is little to lose because otherwise you probably need to replace them - which is not a huge deal.

But I would still advise testing on a tiny area of pearl first.
 
Be careful if buying abalone or mother of pearl, or other non-plastic replacements, as most of the cheaper ones have a layer of resin (read plastic) over the natural "pearl". This gives no advantage at all.

When you find one you fancy, message the seller and ask if the surface is totally natural and unadulterated. Problem is that a lot of the sellers are far away and either don't understand what you're asking or... lie.

Also, if you fancy cutting your own MOP beware. The dust is said to be a carcinogen.
 

Social

New! Social Feeds

Look out for the navigation icon:

Follow CafeSaxophone

Latest Song of the Month

Trending

Forum statistics

Topics
32,064
Messages
578,448
Members
8,130
Latest member
tommyliehe
Back
Top Bottom