- Messages
- 8,133
- Location
- Near Evesham, Worcestershire
I bought an old Karl Meyer (Orsi) tenor and have used it as a donor to supply various parts (hinge rods, pivot screws, guard, key) to my Orsi Pennsylvania tenor. The scrappy and now scrap KM body has recently been utilised to try different bare brass finishes (see other thread).
Anyhoo... the Penn's pads look original whereas the scrap KM's, still in its key work, are very new with few showing any sign of use or seat impressions. The seller did say she'd had it re-padded but it never played properly afterwards. I could immediately see none of the bottom stack pads closed properly so this confirms she wouldn't have played it much as it wouldn't play!
I don't know what make the pads are. I'm guessing cheap as the tech work may have been amateur/bodged for it not to work. All key cups appear to be the same sizes on both horns so the pads are interchangeable.
So, can I re-use them and swap them out to the recipient horn?
Seems a shame to waste them. I'm trying to harvest as many bits from the dead horn as I can.
When I stripped my YAS-21 pads out recently I tried heating a couple of cup backs with my new hot air torch to remove the pads without damaging them. This I could do OK but the glue/shellac on the back of the pad pulls away from the cup in spikes and then sets in that pattern. This would make them tricky to re-use but I'm guessing some of you have tried this money saving exercise before so may have found it possible, or a waste of time?
If it IS possible, how did you do it and get around the spikey gluey pad backs?
Thanks for any insight.
Anyhoo... the Penn's pads look original whereas the scrap KM's, still in its key work, are very new with few showing any sign of use or seat impressions. The seller did say she'd had it re-padded but it never played properly afterwards. I could immediately see none of the bottom stack pads closed properly so this confirms she wouldn't have played it much as it wouldn't play!
I don't know what make the pads are. I'm guessing cheap as the tech work may have been amateur/bodged for it not to work. All key cups appear to be the same sizes on both horns so the pads are interchangeable.
So, can I re-use them and swap them out to the recipient horn?
Seems a shame to waste them. I'm trying to harvest as many bits from the dead horn as I can.
When I stripped my YAS-21 pads out recently I tried heating a couple of cup backs with my new hot air torch to remove the pads without damaging them. This I could do OK but the glue/shellac on the back of the pad pulls away from the cup in spikes and then sets in that pattern. This would make them tricky to re-use but I'm guessing some of you have tried this money saving exercise before so may have found it possible, or a waste of time?
If it IS possible, how did you do it and get around the spikey gluey pad backs?
Thanks for any insight.
