Tech/maintenance Polishing a Mouthpiece

PigSquealer

Connoisseur of applesauce
Messages
5,903
Location
Los Angeles🇺🇸
Level
Awful
Here’s my version of shining up a crusty old mouthpiece.
This article from Music Medic was used as primer.

The abused victim for this thread is a Selmer S 80 *C. Yard sale acquisition. Luckily it was stuck on the neck of Committee lll. Had to buy that too:rolleyes:
1732480007771.webp


First step was removing the ick factor.
Tepid water and Dawn dish soap. Be careful if alternate soap is used. Like Palmolive dish soap. It contains sulfur. HR does not like sulfur !
I wasn’t interested in vinegar treatment.
This below after a hour and a few passes with a soft toothbrush.
1732479425024.webp
 
Last edited:
Supplies used.
Recycled container for water bath. Rubber bath pig optional.
The Scotch Brite in the lower right is burgundy and white grit.
600, 1000, 2000 grit wet use sandpaper.
Strips of 100% cotton cloth. (Old T-shirt)
Broken drumstick, long taper on end.
4 x 4 cotton. (Webril wipes)
Liquid or paste white (fine) polishing compound.
100% carnauba wax. Just about any will do.
1732480325529.webp
 
Mount the drumstick taper up in bench vise.
Wrap the cotton square on end to protect inside of mouthpiece. The flat area helps keep the mouthpiece from turning / moving.
1732482257980.webp


Just below I placed a short table covered with towels.
This helps maintain the mess and a little insurance if I happen to drop it.
1732482379625.webp


Cover the table and facing with masking tape.
1732482548207.webp
 
I started with the heavy grit burgundy Scotch Brite. Slightly wet and long even light pressure strokes length wise. This may take a couple of times going over the piece. Don’t be too aggressive too soon. You’ll end up with miserable gouges that will be difficult to remove.
1732482981566.webp

Turn the stick as needed.
1732483168528.webp


Dry the part and look often. The direction worked should be visible.
I stopped when I did not detect more of the brown being removed.
1732483409738.webp
 
Next step the white Scotch Brite was used wet. This time in a cross direction to the first. You don’t want to make the scratches deeper. This begins the process of knocking them down. Each step plan on ten to fifteen minutes. My total time start to finish was about two hours. Including taking pictures.
1732483607743.webp


As in the previous post stop and inspect the work.
The working direction should be visible but finer.
1732483705867.webp
 
Last passes with 1000 grit wet @ 45° opposite direction of last (blue).
The lengthwise final with 2000 grit wet (red). This could also be done with a 1500 grit in the middle.
1732486230646.webp

1732486266522.webp

Hopefully by this time minimal to no directional marks or swirl should be visible.
I prefer to be a little underworked than overworked. I can always back up a step and redo it.
1732486415808.webp


The protective tape has done its job. Hopefully you have stayed away from the rails !
Time to peel that off, dry the entire part and replace it.
1732486593771.webp


Don’t throw the piggy out with the bathwater !
 
Glove on using fingertips. Attempt a small stroke, circular motion with the polishing compound.
1732487536015.webp

Light pressure shoeshine style polishing between coats. Use the long cotton scraps.
Do this until you’re reasonably happy with texture. Gloss comes from the wax.
1732487718087.webp

1732487850126.webp

1732487919247.webp

1732488022974.webp
 
Oops! I don’t have pictures from this mouthpiece being waxed:confused:
Do apply the wax liberally.
1732489517883.webp

Let the wax dry to a light haze. Then hand polish with soft terry cloth. Keep turning the cloth as to not use the same area.
1732489599441.webp

Repeat as necessary to achieve the desired gloss.
1732489805822.webp

1732489852419.webp

1732489894114.webp


Obviously I used an automotive carnauba wax. Last step. Washed once again in Dawn dish soap.
1732489964115.webp
 

mouthpiece-cleaning-before3.jpg


mouthpiece-cleaning-after.jpg
The more information sources the better. I had not seen this above before. Wish I had. Always good to study multiple articles.
Thanks for adding link to post.
 

Similar threads... or are they? Maybe not but they could be worth reading anyway 😀

Social

New! Social Feeds

Look out for the navigation icon:

Follow CafeSaxophone

Latest Song of the Month

Trending

Forum statistics

Topics
32,063
Messages
578,432
Members
8,130
Latest member
tommyliehe
Back
Top Bottom