- Messages
- 8,133
- Location
- Near Evesham, Worcestershire
What we really need is a pad with a synthetic sealing material, with no absorbent felt centre, which is also fully waterproof so that no CC can be absorbed, and non-stick, and completely impervious to air to boot.The problem with old pads is most likely to be that the felt core of the pad has become saturated with calcium carbonate (CC) - AKA scale...the white stuff you find in your kettle.
During playing the pad gets wet. Over time the waterproofing properties of the leather breaks down and moisture is absorbed into the pad. This can cause the pad to swell very slightly - and to shrink when it dries - but provided the pad's been well set it's not usually an issue.
With each wetting and drying cycle tiny deposits of CC are left behind, and over the years this builds up until a hard layer forms underneath the leather.. This reduces the flexibility of the pad - and it also reduces its ability to accommodate any expansion/contraction during playing...which leads to leaks forming as the pad takes on moisture.
The problem is exacerbated by uneven toneholes. If they're dead flat across the rim there's much less need for the pads to be flexible.
Add to that a self levelling base, individual pad height adjustment on all but the two tiny octave pads, a quieter action than traditional pads, and the ability to remove or replace a pad in seconds to wash and replace it.
Then make them really long lasting and user replaceable (after initial installation, and a set up by a NAMIR tech).
Then you'd have removed the variables that are spit and CC from your old leather and felt and cardboard pads. Yeuckkk.
They're coming... not long now...
