Intonation Newbie fine tuning

crward77

Member
Messages
19
I was going to play along to some tunes the other day, but wanted to fine tune my sax. I read you move your mouthpiece tighter to raise the pitch slightly, but it was already on pretty tight and I didn't want to force the cork. Was still a little flat. Is that normal? Does that make sense?
 
have you greased your cork?
is your sax brand new?

It is quite common for the mouthpiece to sit tight on the cork. Plenty of cork grease and generous screwing the mouthpiece onto the cork with usually help get it on a little further.

As a beginner, it is common for you to be out of tune because your embouchure not really good yet.

If your sax really won't tune, you could take a strip of really, really fine emery cloth and rub all the way around the cork a tiny, tiny bit, then re-try the mouthpiece on the cork, repeat very gently as necessary.

in all probability, you just need lots of cork grease and to screw the mouthpiece onto the cork.
 
Reality is that there isn't a formal standard for the inside of the shank of the mouthpiece. So the cork really needs to be adjusted.

Don't use emery cloth, it leaves grit behind, possibly embedded in the cloth. Use wet & dry paper dry. 400 grit is a good starting point. The cork is already compressed, so expand it with gentle heat by passing it through the steam from a kettle. Dry and wrap masking tape around the neck next to the cork. This stops you from scratching the neck when you slide off the cork and sand the neck. Use a strip of the wet and dry. You're aiming for a firm sliding fit that will be eased by cork grease. The cork should have parallel, not tapered sides. A chamfer at the mouthpiece end is good, but difficult without sanding the neck as well.
 
If you have a workshop with a bench vice, it works quite well to get a wooden dowel that fits snugly into the end of the neck and use that to support the neck while sanding. You can then use the "shoe shine" method with a strip of sandpaper about 1/2" wide. I generally sand 4 strokes back and forth N, S, E, and W turning the neck each time. Like what has been previously mentioned, it should be the goal to make the cork as cylindrical as possible to match the shank of the mouthpiece.
 

Social

New! Social Feeds

Look out for the navigation icon:

Follow CafeSaxophone

Latest Song of the Month

Trending

Forum statistics

Topics
32,061
Messages
578,384
Members
8,129
Latest member
Bartman
Back
Top Bottom