I need a new neck cork. I play an older Martin and a rather modern mouthpiece. The I.D. of mouthpice bore is c 16,5 mm, the O.D, of the neck is c 14,0 mm and c 30 mm down the cork is where I'm in tune. So it's tight. A 2 mm thick cork and there is less than 1 mm left after sading it cylindrical. Another thing I would like to point out is to not push too much if you are sanding the cork and using a bench peg. You can see a little flair on the tip and that's made when the neck cork was sand down. It's a 1938 Martin Handcraft so many mew neck corks over the years. No rings on these old saxes. Add a piece on the neck gives me more flexibility when it comes tunning. The old cork is too long c 50 mm. I just need 35 mm. Is it more than me who have problems like this? New sax or/and new mouthpiece.





