Please publish your results 🙂
I've sent Noel the measurement requirements
@JayeNM sent me a while ago. We'll each try and do the same measurements soon as an interim solution (in case mine sells!) and then hope to meet up in the next few months to do a side by side comparison, with photos ideally.
I don't think JayeNM would mind if I repeated the suggested measurements here:
"OK, so you want to take some measurements along the body tube, the diameter of the body tube. Exterior diameters of the tube, using calpers.
Start at the bottom of the ferrule where the upper bow attaches to the straight tube. that is #1
2) go down to maybe the bis key hole, and center the calipers on the center of the hole and take a tube diameter measurement there. If the calipers are obstructed by the keywork, pick a different hole. The A, the G for example.
3) do the same thing again on lower stack, either the D hole or E hole.
4) do the same thing you did in 1) except measure at the bottom of the ferrule which attaches the body tube to bow.
5) using a tape or long rule, measure the LENGTH of the body tube from the upper to lower ferrules.
6) stand the horn up and measure the distance from the bottom of the bow to the bottom of the bow ferrules. I hope the bowguards on each horn look of similar dimension, here.
7) get the calipers in between the vertical legs of the bow and measure the distance between the surfaces of the bow legs (this is to determine if bow curvature is the same or not).
8) back to the upper bow, measure the diameter of the bow tube/elbow at the very top of the bow.
9) measure the upper bow at the bottom-most curve of the upper bow, near the water key
10) Measure the neck receiver diameter opening"
I
think I can follow this but until I have the horn in front of me...
If anyone needs any other measurements, please post.
Once done, we'll publish on this thread for each horn.