^^^^
Thanks.
I just straightened the upper pin
(red area), that is covered by a gray plastic sleeve when on the horn, so it is square to the wider lower pin.
Pic is before it was straightened.
For the lower bent part, that attaches to the tube, a steel flat bar, blue area, then press the top down to make it flat, as it should be. Might need a shim in white area.
There is a hole in the bent part as well.
Pic just to show general idea not final placement.
I can machine what's needed, have bar stock etc etc, and have lotsa tools, but my concern is to not fracture that part.
Was curious if it would be wise to heat it a bit first and how a tech would apply the heat.
Funny story about letting your teenage children not use their own horns.