zebrafoot
Member
- Messages
- 69
- Location
- Oxfordshire, UK
Hello everyone,
I'm a reasonably experienced bari/tenor player and I recently bought a very budget instrument on eBay. Described by the seller as "excellent condition", it is of course not, but I think with a bit of effort I can make it usable. As it was super-cheap, I'm not bothered about having a go to fix whatever needs doing.
I noticed a leak from the A key where a previous owner had stuck a big fat felt pad under the key where it touches the Bis Bb - this meant that the Bis Bb bottomed out before the A touched down properly - I've removed this, trimmed it and ironed it and reaffixed it so that there's no daylight any more. Similarly, there's an issue with the lever that seats the G# so that it doesn't quite get forced down enough, but I can see that that is caused by a groove worn in the cork on the G# and have work-arounds for it.
So after I've done the above fixes, I note that I'm able to play reasonably well down to C, assuming I use enough air support, but the F# is really dodgy. The F# above the stave is quite clean and clear, but the low one is quite horrible and difficult to hit. I'm not an alto player so I accept that it could be due to bad technique on my part. However, is there anything I should be looking for with respect to the F#? I have the Stephen Howard manual and I can't see any specific reference to this one being an issue.
Pete
I'm a reasonably experienced bari/tenor player and I recently bought a very budget instrument on eBay. Described by the seller as "excellent condition", it is of course not, but I think with a bit of effort I can make it usable. As it was super-cheap, I'm not bothered about having a go to fix whatever needs doing.
I noticed a leak from the A key where a previous owner had stuck a big fat felt pad under the key where it touches the Bis Bb - this meant that the Bis Bb bottomed out before the A touched down properly - I've removed this, trimmed it and ironed it and reaffixed it so that there's no daylight any more. Similarly, there's an issue with the lever that seats the G# so that it doesn't quite get forced down enough, but I can see that that is caused by a groove worn in the cork on the G# and have work-arounds for it.
So after I've done the above fixes, I note that I'm able to play reasonably well down to C, assuming I use enough air support, but the F# is really dodgy. The F# above the stave is quite clean and clear, but the low one is quite horrible and difficult to hit. I'm not an alto player so I accept that it could be due to bad technique on my part. However, is there anything I should be looking for with respect to the F#? I have the Stephen Howard manual and I can't see any specific reference to this one being an issue.
Pete
