WillieJames
New Member
- Messages
- 1
- Location
- Portland, Or
Been reading threads from your site for years but just never registered. I'm a session/touring musician of the last 20+ yrs and a saxoholic. I've been a member of the Cherry Poppin' Daddies for the past 12 yrs and had the great fortune to tour Europe, Australia, South Korea and our great 50 over here. I was just on a couple of tours in the UK this past summer with Ural Thomas and the Pain playing a slew of club shows and festivals including Green Man and End Of The Road, finishing up with the Jools Holland show.
I became curious about sax repair about 8 yrs ago and took a job apprenticing with a tech at a local music store, learning the basics of padding, corking, regulation and adjustment. I've learned quite a bit since then from The Complete Woodwind Repair Manual and tips from forums like Cafe Sax. About 6 yrs ago I began learning about mouthpiece design and refacing which later lead to an understanding of the effects of the sax neck on timbre, response and intonation; tenon/receiver fit, neck taper and shape. The sax is an endless source of fascination. Saxoholic.
I play on Selmer Mk VI (186xxx) and Yamaha Custom Z tenors, Custom alto, YBS-52, and Buffet soprano. On tenor I play a Ralph Morgan refaced STM and a personally refaced STM (modeled after Ralph's work with a larger tip opening). A Morgan Excalibur on alto, and Link HR on sop and bari.
Looking forward to exchanging ideas and bits of knowledge with the members of Cafe Sax,
Willie Matheis
Williematheis.com
I became curious about sax repair about 8 yrs ago and took a job apprenticing with a tech at a local music store, learning the basics of padding, corking, regulation and adjustment. I've learned quite a bit since then from The Complete Woodwind Repair Manual and tips from forums like Cafe Sax. About 6 yrs ago I began learning about mouthpiece design and refacing which later lead to an understanding of the effects of the sax neck on timbre, response and intonation; tenon/receiver fit, neck taper and shape. The sax is an endless source of fascination. Saxoholic.
I play on Selmer Mk VI (186xxx) and Yamaha Custom Z tenors, Custom alto, YBS-52, and Buffet soprano. On tenor I play a Ralph Morgan refaced STM and a personally refaced STM (modeled after Ralph's work with a larger tip opening). A Morgan Excalibur on alto, and Link HR on sop and bari.
Looking forward to exchanging ideas and bits of knowledge with the members of Cafe Sax,
Willie Matheis
Williematheis.com
