Tech/maintenance Help - My Neck is Stuck !

"DO NOT use wd40 or similar products as these contain a solvent."
Hi Fraser,
WD40 (Water Dispersant, 40th attempt), is a natural composition of Hydrocarbons and contains no solvents. It is well worth looking up the recommended number of uses it has, you will be amazed!!!!!!!!!!!! ;}

John.
 
I'm talking the smallest bit here not a massive finger full, works on my saxes without scoring the bore, in perticular on my Silversonic which has a very tight double socket neck.....each to there own i guess...

Like you my yas 62 has always had a very tight tenon and that slightest smear makes all the difference,sorry if the experts say that's wrong but it works for me...john
 
If I have a tight fit between the Neck and the Tenon I prefer to use fine grit paper or wire wool on the neck to get a perfect fit. Thus no need to grease which creates problems down the road. Plenty of meat on the neck to do this and often only a small amount needs to come off. Saves constant frustration!
 
Rhys,

glad your sax is sorted, Ive been in Greece for a fortnight so couldnt reply. I would have gone down the route Manlio (MMM) suggested using plus gas or wd40. Both of which should not damage lacquer. ( ive used them on all kinds of instruments with no detriment.

The powdery substance you described could well be:

1. lacquer - often instruments from the far east - however well made - have the tenons laquered which IMHO will obviously wear away if the tenon is, and should be, snug.
or

2. residue form silver polish.

either way You can clean your tenon with 0000 grade wire wool- ensuring you mask off the exposed side of the tenon shoulder so you dont damage the finish.
 
MIT Mission impossible theme tunes?
MIT Mechanical indestructible tights?
MIT Motorised igloo thaw protection?
MIT Mobile Industrial strength Toilets?
 
Couple of thoughts brought on by this thread:
1. The main ingeredient in WD-40 is fish oil.
2. WD-40 leaves a residue that is difficult to remove unless you use acetone or naptha, either of which is highly flammable.
3. An excellent cleaning compound for brass is what I use in clock repair. 4 oz acetone, 8 oz of Murphy's oil soap, and 12 oz of ammonia. Mix the stuff outdoors, in a 1 qt glass canning jar. (Stay upwind of it; the ammonia fumes are nasty.) It will make a white gloppy precipitate, that in about 1/2 hour goes away. The mixture will then have a medium honey color. Add sufficient water to make one gallon. I use a plastic water jug, with a screw top. Soak the brass part to be cleaned for ten minutes to 1/2 hour, depending on how much green gook is on it. Scrub the part with an old toothbrush, and rinse with water. For sax necks, because the stuff removes lacquer, I use a rag saturated with it to scrub off just the portion of the neck that goes into the receiver, and hold it while rinsing so that it does not run back onto the lacquer.
4. The powdery residue on the neck is probably an oxide, either of copper (if red) or zinc, (if white). Either one will leach out of brass whenever it comes into contact with acid. Saliva is typically slightly acidic, and if the instrument is new, the brass is not completely leached out and stabilized.
5. I never grease the neck of my saxophones. I keep the neck clean by polishing it at teh receiver portion with a piece of chamois, or my linen flute swab.
6. Do not use silicone grease on any part of a musical instrument. Silicone grease never stops migrating, and it is nearly impossible to remove with out using exotic chemicals. My father, who was a Westinghouse Engineer, told me about a Westinghouse tech who accidentally dropped a tiny spot of silicone grease on the wing of a US Air Force Experimantal aircraft. He then tried to wipe it up with a rag. Eventually, he gave up, when he had a spot about three feet square that was coated with grease. Ultimately, Westinghouse had to pay to have a new aluminum skin put on that wing, before the aircraft could be flown.
 
Last edited by a moderator:
WD40 (Water Dispersant, 40th attempt), is a natural composition of Hydrocarbons and contains no solvents.
Not wanting to start an argument over weather, or weather not to use a can of wd40 on your sax, please bear in mind the following: Firstly, and obviously it contains a solvent...Secondly, it does not contain fish oil..only mineral oil....Thirdly,containing both oil and solvent it will not dilute in water.....ok?
 

Social

New! Social Feeds

Look out for the navigation icon:

Follow CafeSaxophone

Latest Song of the Month

Trending

Forum statistics

Topics
32,072
Messages
578,572
Members
8,133
Latest member
walthang
Back
Top Bottom