Couple of thoughts brought on by this thread:
1. The main ingeredient in WD-40 is fish oil.
2. WD-40 leaves a residue that is difficult to remove unless you use acetone or naptha, either of which is highly flammable.
3. An excellent cleaning compound for brass is what I use in clock repair. 4 oz acetone, 8 oz of Murphy's oil soap, and 12 oz of ammonia. Mix the stuff outdoors, in a 1 qt glass canning jar. (Stay upwind of it; the ammonia fumes are nasty.) It will make a white gloppy precipitate, that in about 1/2 hour goes away. The mixture will then have a medium honey color. Add sufficient water to make one gallon. I use a plastic water jug, with a screw top. Soak the brass part to be cleaned for ten minutes to 1/2 hour, depending on how much green gook is on it. Scrub the part with an old toothbrush, and rinse with water. For sax necks, because the stuff removes lacquer, I use a rag saturated with it to scrub off just the portion of the neck that goes into the receiver, and hold it while rinsing so that it does not run back onto the lacquer.
4. The powdery residue on the neck is probably an oxide, either of copper (if red) or zinc, (if white). Either one will leach out of brass whenever it comes into contact with acid. Saliva is typically slightly acidic, and if the instrument is new, the brass is not completely leached out and stabilized.
5. I never grease the neck of my saxophones. I keep the neck clean by polishing it at teh receiver portion with a piece of chamois, or my linen flute swab.
6. Do not use silicone grease on any part of a musical instrument. Silicone grease never stops migrating, and it is nearly impossible to remove with out using exotic chemicals. My father, who was a Westinghouse Engineer, told me about a Westinghouse tech who accidentally dropped a tiny spot of silicone grease on the wing of a US Air Force Experimantal aircraft. He then tried to wipe it up with a rag. Eventually, he gave up, when he had a spot about three feet square that was coated with grease. Ultimately, Westinghouse had to pay to have a new aluminum skin put on that wing, before the aircraft could be flown.