Exactly. It's all down to the pitch that has been decreed at that time for that country/region. So back then presumably piano tuners would tune to A = 453 or whatever.But were pianos tuned "high pitch" at that time?
Exactly. It's all down to the pitch that has been decreed at that time for that country/region. So back then presumably piano tuners would tune to A = 453 or whatever.But were pianos tuned "high pitch" at that time?
My Buescher c-mel is 24" in that dimension. The shift from high pitch to low pitch did not "just occur" but they co-existed for quite some time. I know Uwe Steinmetz has a ~ 1860 Adolphe Sax that is low pitch and I have also never seen a c-mel in high pitch flavor (that doesn't mean they don't exist).More time gives better results! There is a flat mark.View attachment 22043View attachment 22044
I trust your measuring it accurately. I would say it is low pitch. Normally a C melody would measure 24-1/4-25 inches. I just measured a Martin and Conn C @ 24-1/2.Hello.. 610 millimetres [or maybe 611]. I make that 24.016 inches.View attachment 22042
And that would be great news. So I wonder in that case what the #P means?I would say it is low pitch.
I don't think so.I would say it is low pitch.
High Pitch.So I wonder in that case what the #P means?
Now that you mention it the bell length looks considerably shorter. Tone holes look much lower on the bell area also. Interesting this has LH bell keys like a Selmer model 22. I wonder if measuring your HP tone hole spacing is relative to the sax in question. The chart in post #4 is lacking a C melody.I don't think so.
I refer you to my earlier post (18): I have a HP XXC C-melody (marked #) Side by side it stands the same as my Buescher, Martin and Conn. Look closer though and you'd see that the bell (and therefore the total length) is shorter. Examine the toneholes, and whereas the upper ones match pretty well, as you go down the body they diverge more, most obviously at the bell keys.
High Pitch.
🙁
Very interesting! Don't judge a horn by its size!I don't think so.
I refer you to my earlier post (18): I have a HP XXC C-melody (marked #) Side by side it stands the same as my Buescher, Martin and Conn. Look closer though and you'd see that the bell (and therefore the total length) is shorter. Examine the toneholes, and whereas the upper ones match pretty well, as you go down the body they diverge more, most obviously at the bell keys.
High Pitch.
🙁
When I was at college I had a high pitch soprano. I'd play it in the big band but nobody there seemed to know about high pitch and low pitch so I just got a lot of dirty looks sometimes.and you could see that he had the mouthpiece set right at the very end of the crook. I guess he must have had one hell of an embouchure!
I had a similar situation, just it wasn't a big band when I took out my 1898 Conn alto unaware of the fact that the horn is high pitch (there is no stamp indicating that).When I was at college I had a high pitch soprano. I'd play it in the big band but nobody there seemed to know about high pitch and low pitch so I just got a lot of dirty looks sometimes.
I guess back then maybe it was before low pitch so they wouldn’t have. Or maybe Nostradamus predicted pitch warsConn alto unaware of the fact that the horn is high pitch (there is no stamp indicating that).
Low pitch was definitely around, many of the early Adolphe Sax altos and tenors were LP but I believe Low Pitch was more a European thing whereas High Pitch was more common with the early American manufacturers. At least I think I read something like that but it was on the internet.I guess back then maybe it was before low pitch so they wouldn’t have. Or may Nostradamus predicted pitch wars
You're probably right but I think back then there may have been so many different pitches anyway, not necessarily due to era but also geographically, that nobody bothers marking.Low pitch was definitely around, many of the early Adolphe Sax altos and tenors were LP but I believe Low Pitch was more a European thing whereas High Pitch was more common with the early American manufacturers. At least I think I read something like that but it was on the internet.
Pitch everything was around until ISO 16…..in 1955Low pitch was definitely around, many of the early Adolphe Sax altos and tenors were LP but I believe Low Pitch was more a European thing whereas High Pitch was more common with the early American manufacturers. At least I think I read something like that but it was on the internet.

"Before I go, let me point out that the difference between 435 Hertz and 440 Hertz is barely perceptible. Note that the second of my links is a tone generator. I opened it and started it going. It defaults to 440 Hertz because they have that kind of stranglehold on the world. I opened again it in another tab and got it going at 435 and I could not honestly say whether I actually heard the difference or just seemed to hear it because I expected to hear it."Pitch everything was around until ISO 16…..in 1955
Although the treaty of Versailles in 1919 inked it as low pitch A-440![]()
![]()
Concert pitch - Wikipedia
en.wikipedia.org
Wow !A440 (pitch standard) - Wikipedia
en.wikipedia.org

