Temp fix solves the issue...
...but is the permanent fix to beef up the worn cork on the lever. It has a typical wear indent, but the original thickness cork wouldn't be quite enough...
That's not a tiny leak, that's absolutely MASSIVE! I'm amazed it plays at all. Makes me wonder about the rest of the repad. How in the world could that have been missed? I'd be tempted to take it to another tech if that's typical of his quality of work.
My little joke... tiny.
"His" work is mine. Please have a look at my DIY pad thread.
I'd gotten so far yesterday but had to break off to cook the roast lamb so had just used my (poor) eyesight without my leak light. I should have spotted this one of course... rushing.
I've been over the whole horn with the light now. Three or four other pads needed adjustment by 0.1mm or 0.2mm to remove leaks.
With these skinned pads which don't form a seat (rather than the TruSeal open cell neoprene predecessors which did) I can see a couple of tone holes are minutely off level. So I either need a more accommodating sealing material (closed cell, low compression set, neoprene is next to try) OR, like Jim Schmidt, I specify flat tone holes as a requirement of my system.
I'll try the neoprene first, but start looking more closely at good value tone hole files.
Remember, I'm just experimenting, and padding techniques are something I'm still learning. But at least there's no shellac, picks, irons, etc involved. Just nuts, bolts, washers...