- Messages
- 4,216
- Location
- london
Hi does anyone play one of these..I know they come with their own lig..I have a great toned kanee Florida but can only play legere reeds at the mo.. Does a regular basket ligature fit these..
Trouble is i have to do it up so tight it chokes the reed. If i use a rovner i use the ones with metal on the bottom. I really find a cheap metal 2 screw lig better for the legeres.What about a Rovner ligature? They're very secure and they don't scratch or dent mouthpieces like a lot of the metal ones do
Lol...i really dont want another piece..lucky enough to have the lakshmi..at the other end the kanee florida is great but just needs a lig..I really prefer the 2 screw cheap types..good tip ill have a go..I know you're probably desperate for a reason to buy another new mouthpiece ... but with synthetic reeds I just cut up bits of those little white sticky address labels and put them on the back of the reed. Makes the reed a bit thicker and helps the ligature to grip.
That sounds like you haven't lubricated the ligature properly. It's difficult to have a ligature too tight. IMO.Trouble is i have to do it up so tight it chokes the reed.
I find cheap 2 screws are usually great, but must be a good fit. Rovners are a lot more forgiving of the mouthpiece taper, but as mentioned should be lubricated properly.I really prefer the 2 screw cheap types..good tip ill have a go..
See here:I always use Rovner and never lubricated them or does that only apply to the ones with metal?
Never knew that Pete, I should have read the instructions that came with the lig's instead of throwing them in the bin.
strips of leather are also fine , or cardboard.I guess the same could be achieved by adding layers of masking tape, but the cork is just cleaner and compresses to the right thickness.
Nice tip..thanksI have adjusted a metal baritone lig which was slightly too wide for the mouthpiece by gluing some strips of thin cork (.5 or 1mm, depending on how much of a gap needs to be taken up) to the top inside of the ligature. This has a dual purpose: it makes the lig diameter smaller and avoids any scratches to the top of the mouthpiece.
I guess the same could be achieved by adding layers of masking tape, but the cork is just cleaner and compresses to the right thickness.
