Miscellaneous Disconnecting a gas (real gas) cooker

Jimmymack

Senior Member
Messages
2,260
Location
London
Level
Could be better
A question about real gas. I never expected to ask a question like this on a saxophone site but I think there's somebody here who knows the answer. I need to disconnect a gas cooker, standalone thingy, and get rid of it. I've read, loads of advice from strangers on the internet, that I can just do this myself but it makes me very nervous, it's been in place for at least 20 years and it looks pretty murky back there.

So, first off, should/could I attempt this without running the risk of blowing us all to kingdom come, do these things self-close (seems unlikely to me, certainly in my flat). Or, should I just pay the money and get somebody who knows what they are doing to do it and lock it off? I'm not planning on replacing it but I would like the option to be there. Clearance people say they will do it but they don't seem to be any more professionally qualified than me. There doesn't seem to be a turn off valve anywhere in the vicinity which would have made me feel better.

Anybody know, Eddie @eb424, are you out there?
 
Do your own research, but IF it has a bayonet fitting...



If it's to be permanently disconnected, as you suggest, get a Gas Safe engineer to cap it off permanently. This is because a bayonet fitting may leak now or in the future.
 
Look at the bright side. When you blow up your house, at least you can say an anonymous saxophone player on the internet said it was ok. Seriously though, what did you think would happen when you disconnected a gas line when there is no shut-off valve. Do a trial run with your plumbing just to see what will happen when you disconnect a water line without shutting off the water. It will make a huge mess, but at least it won't kill anybody, and your house will still be standing.
 
Not illegal. But as said, with no shut off valve it's more risky.

From: https://www.hse.gov.uk/gas/landlords/141114-responsibility-disconnecting-reconnecting.pdf

"The temporary disconnection/reconnection (at the same location) of a self-sealing appliance connector where a gas cooker is not being installed for the first time or repositioned permanently is not deemed ‘gas work’ and therefore may be carried out by a non-registered person(s), for example, when a home owner temporarily removes the cooker when cleaning. The alteration of any gas installation pipework to allow the cooker to be permanently repositioned is considered gas work. However, whenever any person when at work disconnects or re-connects a self-sealing connector must be competent to a level that will ensure that the action of doing so does not cause gas to escape.
Note 3: In most cases when the cooker hose is disconnected from the self-sealing connector, there will be a residual smell of gas. Therefore, it is strongly recommended that as a minimum, an appropriate leak detection fluid (LDF), or gas detector is used to confirm that there is no gas escaping from the self-sealing fitting. For added security, proprietary bayonet blanking fittings are also available and can be fitted to the bayonet opening.
Circumstances may dictate that it would be a safer option to undertake a more permanent method of sealing off a cooker connection point which is intended to no longer be used, for example, where it is known that the cooker connection will not be reused, or the cooker moved to an alternative location or property e.g. by using a screwed plug, cap or compression fitting in place of the bayonet fitting. This option would involve gas work and must only be carried out by a suitably qualified registered gas engineer."
 
Last edited:
Thanks, I think it only needed me to post to realise that I wasn't going to do this. A search on the web comes up with more people telling you that it's easy, and ok and legal, than you might hope. In fact you have to dig to get the obvious answer, get a professional.
 
Or dig to get the correct answer on the Government website.

The full regulations, here: https://www.hse.gov.uk/pubns/priced/l56.pdf

Page 14:

"“work” in relation to a gas fitting includes any of the following activities carried out by any person, whether an employee or not, that is to say –
  1. (a) installing or re-connecting the fitting;
  2. (b) maintaining, servicing, permanently adjusting, disconnecting, repairing,
    altering or renewing the fitting or purging it of air or gas;
  3. (c) where the fitting is not readily movable, changing its position; and
  4. (d) removing the fitting;
but the expression does not include the connection or disconnection of a bayonet fitting or other self-sealing connector."
 
Also, unless you still have other gas appliances, you ought to get the meter disconnected or you will continue to pay the daily standing charge.
 
No I just want rid of the cooker we have gas central heating and we're stuck with that for the foreseeable future. Funny thing is I looked for local GasSafe engineers on their website and there are at least a dozen of them listed within about half a mile of where I live, who knew that I was rubbing shoulders with registered gas engineers on a regular basis?
 
A question about real gas. I never expected to ask a question like this on a saxophone site but I think there's somebody here who knows the answer. I need to disconnect a gas cooker, standalone thingy, and get rid of it. I've read, loads of advice from strangers on the internet, that I can just do this myself but it makes me very nervous, it's been in place for at least 20 years and it looks pretty murky back there.

So, first off, should/could I attempt this without running the risk of blowing us all to kingdom come, do these things self-close (seems unlikely to me, certainly in my flat). Or, should I just pay the money and get somebody who knows what they are doing to do it and lock it off? I'm not planning on replacing it but I would like the option to be there. Clearance people say they will do it but they don't seem to be any more professionally qualified than me. There doesn't seem to be a turn off valve anywhere in the vicinity which would have made me feel better.

Anybody know, Eddie @eb424, are you out there?
Hi @Jimmymack legally you can remove it if competetant.The hose simply pushes in twists and pulls out. It is on a spring mechanism and SHOULD automatically close. Personally I never leave a bayonet and usually remove it and put a plug or cap on it..you can spray with ldf ( leak detective spray) once capped or plugged . You can buy bayonet caps that push in and replace the hose. Better if you can get a gas engineer to tightness test tho its a simple enough job. Sorry about the long time answering on hols in spain and a bit tipsy tbf... lol...are you in London I'm back in the UK Saturday if any good and don't mind assisting if you're not to far from Heathrow.
 
Not only dangerous - illegal.
You can only do any work specified in the user manual, you cannot do anything concerned with the supply or disconnect the appliance.
Not quite correct but sensible..Legally the cooker doesnt require a butterfly valve unlike a hob. The meter will have an ecv which is better shut off to disconnect the bayonet which can legally be done by the op.. better tho to permenantly cap which is simple but as it entails disrupting the gas line needs to be done by a a rgf ..as tightness needs to be tested.
 
Last edited:
Thanks for this Eddie, that’s very clear, or as clear as it can be to someone with an incomplete grasp of the job and would probably qualify as an incompetent. I think the risk I would run doing it myself for the convenience and to save money is a risk too far but at least I know what to expect the engineer to do. Thanks for your offer of help but I’m in NW London and a fair hike from Heathrow, hope you’re having a good holiday, sounds like you are.
 
Look at the bright side. When you blow up your house, at least you can say an anonymous saxophone player on the internet said it was ok. Seriously though, what did you think would happen when you disconnected a gas line when there is no shut-off valve. Do a trial run with your plumbing just to see what will happen when you disconnect a water line without shutting off the water. It will make a huge mess, but at least it won't kill anybody, and your house will still be standing.
It doesn't work like that at all. In the UK, gas appliances are attached using a bayonet cap which locks off the gas supply as soon as it is disconnected. It's not a permanent disconnection, but if you want to remove a cooker to service it or give it a deep clean you can do so without gas escaping. For a permanent removal of the appliance it should be permanently capped off.
 
Well, in the US it's all threaded pipe fittings. The house I live in was built in 1939 and there's a gas connection in almost every room for a space heater. We used to use those when I was a boy; you would disconnect the space heater each spring and reattach it each fall. You just worked fast and had the cap and the pipe tape (or pipe dope, in the days before tape) ready to hand. A bit of gas into the room won't blow up; it has to be within combustibility limits. You don't smoke while you're doing this. No one would have the nerve to do that kind of thing these days, including me.

The biggest worry I would have is that this supposedly self-closing connection wouldn't self-close and then you're running around frantically trying to find the main shutoff for the house. I had a minor flood a few years ago when something similar for the clothes washer had gotten stuck in the open position and I removed the hoses, thinking it was closed.

Obviously the regulation is much tighter in the UK.
 
When I looked at the connection the absence of an easily found shut off was enough for me to just put the oven back in place, not to mention the grot that has accumulated over the years. The self closer was news to me before I started looking into this and I wouldn’t trust it to work either. I have to say that your description of uncapping a connected gas pipe and quickly attaching a space heater gave me a nasty turn.
 
I live on Westbere Road NW2 which is about 10 minutes walk from West Hampstead, top end of Kilburn or Cricklewood. It's east of Acton. My only experience of getting to Heathrow, the airport, by road is by cab as I don't drive, which usually does go through Acton but beyond that I don't know, I would guess Acton is about 30 minutes away, maybe a bit more. We once we made it in 45 minutes but that was about 5 in the morning, no traffic, with a boy racer as the driver and is a bit unusual and made me car sick. Anyway that's where I live.
 
How in hell is it possible to have gas and no way to shut it off?

Can you imagine not being able to shut-off electricity? I guess not!

I also guess that gas ain't free. So if not after, there must be a valve at the counter.

If not, I would sue the gas company for failure to ensure proper security. There are rather strict rules in the UK regarding electrical appliances and EACH plug is equipped with an ON/OFF switch. In France we don't have that. So I'm shocked if gas is treated so lightly. ️ Now light my fire!

PS: When I used to work in the UK on a regular basis, I often forgot the ON/OFF switch and my laptop would run low on battery while I thought it was plugged. And you know what it was, but the switch was OFF. 😳

KEEP SAFE!
 

Similar threads... or are they? Maybe not but they could be worth reading anyway 😀

Social

New! Social Feeds

Look out for the navigation icon:

Follow CafeSaxophone

Latest Song of the Month

Trending

Forum statistics

Topics
32,064
Messages
578,438
Members
8,130
Latest member
tommyliehe
Back
Top Bottom