Argeebee
Member
- Messages
- 56
- Location
- Netherland
A really clean Cigar Cutter....
.... and the surgical supplies necessary after the shortening.![]()
Well, the term "Palm" isn't really accurate. Most people will hit the high D with the first joiint pad (above the bik knuckle) of the index finger, high Eb with the same joint pad of the middle finger, high F with the same joint pad of the ring finger. You don't actually hit those keys with the center of your palm. You have to be able to operate each of these keys independently, thus using that first joint pad to operate them. Those fingers, of course, are doing double duty as the fingertips are on the pearls. The objective is to have the "palm key" touchpieces low enough that you don't inadvertently open the key when you're moving around on the left hand stack, but high enough that you only have to slightly deform your fingers to go from a pearls fingering to a palm keys fingering. So for example B to D, it's easy to accidentally open Eb if its touchpiece is too high relative to the D touchpiece.
For all my horns, I've spent some time in the woodshed and then made risers where needed. In many case I've later raised them further upon more experience, or lowered them.
Keilwerth top models for a while had adjustable palm key touchpieces; a good idea in concept; I'm not sure whether the implementation lived up to the promise. The fact that no one else has done it makes me wonder if there were some challenges in the execution.
What a clear explanation about the palm keys. When playing and testing I had already tried different methods. But I have not found the right one yet. So for me there is a lot of practice to do.Well, the term "Palm" isn't really accurate. Most people will hit the high D with the first joiint pad (above the bik knuckle) of the index finger, high Eb with the same joint pad of the middle finger, high F with the same joint pad of the ring finger. You don't actually hit those keys with the center of your palm. You have to be able to operate each of these keys independently, thus using that first joint pad to operate them. Those fingers, of course, are doing double duty as the fingertips are on the pearls. The objective is to have the "palm key" touchpieces low enough that you don't inadvertently open the key when you're moving around on the left hand stack, but high enough that you only have to slightly deform your fingers to go from a pearls fingering to a palm keys fingering. So for example B to D, it's easy to accidentally open Eb if its touchpiece is too high relative to the D touchpiece.
For all my horns, I've spent some time in the woodshed and then made risers where needed. In many case I've later raised them further upon more experience, or lowered them.
Keilwerth top models for a while had adjustable palm key touchpieces; a good idea in concept; I'm not sure whether the implementation lived up to the promise. The fact that no one else has done it makes me wonder if there were some challenges in the execution.
I will apply what I have read. Great explanation.
