PiccoloPirate
Senior Member
- Messages
- 1,207
- Location
- South Florida
Not sure of the technical name for the
key hinge tube with pivot, on the lower end of the upper stack, on my old Armstrong Alto Flute.
It, along with the upper pivot, of the lower stack tube and the pivot on the lower end of the G# key tube, all sit into one post.
There is a bit of wobble in all three.
Haven't decided how to fix this yet, but I'm doing a repad, cork and other normal necessary things.
Thought of using a metal epoxy like JB Weld and make the holes in the post fit the pivots tighter.
RenWax as a releasing agent on the pivots and surrounding areas, and a wee bit of the epoxy inserted into the hole, then put the pivot/tube in place until it cures.
Do each one individually, G# first, but be careful as the hole for the two stacks are inline. I can put a thicker wax in the lower stack pivot hole, let it harden, so the epoxy is confined to the upper stack hole.
Same in reverse.
Or, make an insert of metal to put in the hole that is opposite the one getting epoxied, and use a mold release so it comes apart without issue.
Flute plays nice, records nice, from the '60s with a silver head and spent its youth in the Vegas pits, but time to repad etc.
Will take a close look at the interior of the holes as adding material and filing the pivots is another option.
Buying a Kingma, not this week.
This one showed up over a decade ago and the Kingmas were about half the current price.
Thanks for any thoughts/ideas for this project.
Pic of pivot area.
key hinge tube with pivot, on the lower end of the upper stack, on my old Armstrong Alto Flute.
It, along with the upper pivot, of the lower stack tube and the pivot on the lower end of the G# key tube, all sit into one post.
There is a bit of wobble in all three.
Haven't decided how to fix this yet, but I'm doing a repad, cork and other normal necessary things.
Thought of using a metal epoxy like JB Weld and make the holes in the post fit the pivots tighter.
RenWax as a releasing agent on the pivots and surrounding areas, and a wee bit of the epoxy inserted into the hole, then put the pivot/tube in place until it cures.
Do each one individually, G# first, but be careful as the hole for the two stacks are inline. I can put a thicker wax in the lower stack pivot hole, let it harden, so the epoxy is confined to the upper stack hole.
Same in reverse.
Or, make an insert of metal to put in the hole that is opposite the one getting epoxied, and use a mold release so it comes apart without issue.
Flute plays nice, records nice, from the '60s with a silver head and spent its youth in the Vegas pits, but time to repad etc.
Will take a close look at the interior of the holes as adding material and filing the pivots is another option.
Buying a Kingma, not this week.
This one showed up over a decade ago and the Kingmas were about half the current price.
Thanks for any thoughts/ideas for this project.
Pic of pivot area.
Last edited:

