Miscellaneous Advice on epoxy for glass to metal application

MMM

Senior Member
Messages
1,208
Location
SW of London Town
Morning all: does anyone had any good/bad experiences to share using two part epoxy to glue glass to metal? Any recommendations?

Last night's dinner ended up on the floor after the glass top of our round dining table gave way on one of the four metal legs and tipped to one side, so need to find a solution fast.
Reading up on the internet I found that a two part epoxy seems the way to go but wondering on any direct experiences as there's so many on the market (Gorilla, JB Weld, Araldite, etc.), it will have to be clear as the joint is visible from the clear glass top.
Any advice appreciated! Thank you.
 
With any job preparation is key ensure that surfaces have been thoroughly cleaned prior to any work. I would clean with detergent, then rinse and dry and then clean with alcohol (IPA works for me)

Epoxy could potentially be quite messy and look rather unsightly given that most does not dry completely clear and has some colour to it, so if you're going down this route make sure it is for use with glass. Most epoxy glues are very permanent and will be almost impossible to remove once cured if you change your mind

You could try using clear sealant adhesive (used in bathroom fittings sometimes)
 
Araldite Crystal Tubes Epoxy. Strong and clear. Normal epoxy is a bit yellowish, this is clear.

I agree with @greenstripe about IPA. That's Isopropyl Alcohol for the cleaning. Then IPA as in India Pale Ale as a reward after the work.
 
Araldite Crystal Tubes Epoxy. Strong and clear. Normal epoxy is a bit yellowish, this is clear.

I agree with @greenstripe about IPA. That's Isopropyl Alcohol for the cleaning. Then IPA as in India Pale Ale as a reward after the work.
Thank you, just ordering some Araldite!
 

Social

New! Social Feeds

Look out for the navigation icon:

Follow CafeSaxophone

Latest Song of the Month

Trending

Forum statistics

Topics
32,063
Messages
578,425
Members
8,129
Latest member
Bartman
Back
Top Bottom