Tech/maintenance Thin pads for a King saxello

saxmad

Member
Messages
110
Location
North Norfolk
I'm repadding my saxello and will require numerous pads in varying sizes. The original pads are 4mm thick and without resonators.

I'm UK based and now am unsure where I can get these. Dawkes don't appear to stock what I require.
 
Yes I did but they were a pain to install because they were just a smidgen too thick. The original pads measured about 3.85-4m,, whereas the MM pads came in at 4.2mm, just enough extra to cause problems. Especially with the metal resos/rivets sticking out in the back. That's when a hammer and a piece of pinewood become your best friend.
The largest pad was impossible, but the guys at MM went through the stash and cherry-picked a ~4mm replacement.

I'd probably go with Ferree's if I had to do it again

IMG_20231228_132649858.webp


All polished and cleaned and ceramic-coated now (a little extra that I found in the clearance bin at the local auto parts store.
 
I'm repadding my saxello and will require numerous pads in varying sizes. The original pads are 4mm thick and without resonators.

I'm UK based and now am unsure where I can get these. Dawkes don't appear to stock what I require.
MM recommended the small resos but I am not sure whether it was a good choice. The horn sounds great now but that's probably me 😎


Two pieces of advice:

The upper stack height regulation is on the bottom of the body octave key. The only way to get it to where it belongs (highly recommended to replace the cork) is to put it together without the octave key part and then use a needle keyhole file to abrase the point of contact, i.e, grind a dip into it. I used 3/64" cork as starting point. Recommended opening: 2.5-2.7mm tops.

Second, replace all pads, the Saxello is super sensitive to the depth of the seat, that is, how far the center cushion protrudes into the chimney and uneven seat depth will be catastrophic for intonation.
 
Last edited:
This has nothing to do with saxello but everything with thin pads. Today I measured that I need a 2.5 mm thick pad.
Just 0.1 mm above the rim of the key cup. It was not a production error or caused by damage, just a design error.

It is not a big problem as I can make this pad myself, but I found it remarkable.
 

Social

New! Social Feeds

Look out for the navigation icon:

Follow CafeSaxophone

Latest Song of the Month

Trending

Forum statistics

Topics
32,063
Messages
578,431
Members
8,130
Latest member
tommyliehe
Back
Top Bottom