saxmad
Member
- Messages
- 110
- Location
- North Norfolk
As can be seen from the photo, the mechanism is out of alignment - would you carefully bend it back into position or apply heat and bend it back? I personally consider gentle bending but welcome opinions.
Fatigue occurs due to repeated loading, but cracks can occur in a single instance.It's hard to tell without seeing it for real, but from the picture, I would most likely try to bring it back straight. It doesn't look that bad. I'm no expert, like Stephen, but if there are no signs of fatigue in the metal piece, it will probably come back without damage.
For me, the tell tale sign of danger is fatigue, cracks around the bent area. If there are any, don't do it yourself. Get a tech look at it.
Just my to cents! 😳
Please forgive my french. Fatigue was the only term that came to mind after a long day at work... Anyway, I guess the idea is there.Fatigue occurs due to repeated loading, but cracks can occur in a single instance.

Those NormansI'm tempted to apply a saying I learned from Normandy that would translate in 'beware, beware more, beware always...'
My mentor taught me an alternative method of straightening brass parts. That is to repeatedly tap the piece in the direction you want it to move similar to dent removal in brass instruments. This moves the metal in many tiny increments and reduces the chance of cracking or breaking.
Thanks Dr. G. That's everything I needed to know and more. 🙂Tapping on the section that needs to be restored is useful because the bent region is work-hardened and thus more resistant to bending again; the adjacent unbent region will bend more easily. Tapping does not substantially reduce the potential for fatigue, as the mechanism of fatigue directly corresponds to the accumulated plastic strain. Tapping does induce some measure of compressive residual stress at the surface that will impede fatigue crack growth.
Thanks Dr. G. That's everything I needed to know and more. 🙂
