Saxophones neck to mouthpiece connection: tapering v straight considerations.

My thoughts are anything that is not permanent and can be removed without damaging the material of the mouthpiece is fine. Some folks use layers of clear nail polish which comes off with nail polish remover. This is safe on metal and hard rubber mouthpieces. It is best to test a plastic mouthpiece first by applying a small drop of remover to an inconspicuous area and waiting a minute or so to see if the plastic turns tacky. There are so many different types plastics used that it is hard to generalize.

I personally don't know of any solvent that will remove cured epoxy. Scraping and heat are the methods I use.

I once took an old scrap mouthpiece and tried epoxy to see if I could fill tooth marks.. The result, the plastic remained "tacky" around the epoxy and still is today..
 
I've read the instructions regarding the engine laquer I've used on a couple of metal mouthpieces...it say nothing against using it on plastics or rubber - mind you, people spray this stuff on engines which are made of all sorts of different materials including plastics, rubber etc. - so I guess is a good bet.
Time to experiment a bit of this laquer with certain old stock vintage mouthpieces (pretty useless anyway).
 
I am told by someone who repairs fountain pens with epoxy adhesive that soaking in vinegar will usually remove it ,,,,, I haven't tried it!
(If the eopxy is in the 'neck-end' of the mpc, it's not going to come into contact with your mouth)
 
Few of these MPs don't have a perfectly cylindrical bore (no idea why)
Tapered bore is so the mold will release. You'll see some degree of taper on most or all transfer or compression molded pieces (current Meyers and Vandorens, for instance -- the old Meyer Bros had a comparatively huge taper angle)

....I myself have modified a Vandoren V16 small chamber because it wouldn't enter the neck deep enough (a recurring issue with this particular MP)...surely in my diy ways I'm not sure the bore section of that V16 is now cylindrical and I'm bound to think that some other MPs I have (especially those bought 2nd hand) are affected by similar diy modifications.
This is a known issue with the V16s and necks that have a ring on the end of the neck.

As far as improvements, cork is really tough to beat for this application. Sand it to the point where the smallest pieces you use are a snug, slightly difficult fit. For the larger pieces I just tear off a strip of paper to shim it with and discard afterward. I go through a lot of mouthpieces of different sizes. Plumber's tape works but it compresses, too, and needs replacing, and for something that's just for a few minutes or hours, just a strip of paper is fine.

For more permanent solutions, if you have two pieces you use a lot, I would bore out the smaller one rather than adding epoxy or anything to the larger one, but whatever works works.
 
the tip being too small, very old mouthpieces usually are ........you can open them up to be efficiently played as I had it done on a original Conn Eagle for my Conn C melody which I then sold to Raaf Hekkema

I've got a conn eagle presumeably fo c-mel lying around...maybe I'll try that as well, when i'm finished drawing the STM in 3d.. which is rather a daunting task..
 

Social

New! Social Feeds

Look out for the navigation icon:

Follow CafeSaxophone

Latest Song of the Month

Trending

Forum statistics

Topics
32,076
Messages
578,678
Members
8,134
Latest member
banjo
Back
Top Bottom