Mouthpieces Mouthpiece suddenly dead

Messages
144
Location
UK
I have a Rousseau Alto Studio Jazz in a 6, which has been up until recently my favourite mouthpiece and suddenly it doesn't work at all.

I had just received one of my saxes back from my tech and the upper stack just wasn't playing, airy and going up an octave. I assumed there was a leak missed and was planning to take it back to him. The next day I got a different alto out and pretty much the same thing, switched over reeds and that didn't help.

Switched mouthpieces and suddenly back to normal.

There is no damage that I can see, rails and the tip seem fine, it hasn't been dropped. It still seals, but I guess maybe the table is now warped?

I can't imagine what caused it, but obviously something I want to avoid in the future. I did wash it in a small amount of washing up liquid and cold water, and my practice room has a large window and the other day both sax and mouthpiece were sitting in the sun (rare!).

Any thoughts on how that can possibly happen?
 
Last edited:
I can't pick up on any logical explanation for this from what you have said and my experience below probably won't help.
But what I can say is there have been times (only once or twice) when something strange has happened to my set ups out of the blue and to my horror it doesn't go away quickly so change horn and get the same again.
I suddenly couldn't play in the higher register where the neck octave key normally swaps with the one on the upper body. So that was my obvious thought but I couldn't see anything wrong with pads and sealing yet after 10 minutes or so and it still did it. I switched horns and got the same again. SCARED NOW....
I never did fathom it out but after some mouthpiece/reed faffing around and a physical break from playing everything simply started to be OK again.
I'd play the mouthpiece that works for a bit longer then have another go later (I know how absurd this sounds).
But I'd love to know the outcome.
 
I have a Rousseau Alto Studio Jazz in a 6, which has been up until recently my favourite mouthpiece and suddenly it doesn't work at all.

I had just received one of my saxes back from my tech and the upper stack just wasn't playing, airy and going up an octave. I assumed there was a leak missed and was planning to take it back to him. The next day I got a different alto out and pretty much the same thing, switched over reeds and that didn't help.

Switched mouthpieces and suddenly back to normal.

There is no damage that I can see, rails and the tip seem fine, it hasn't been dropped. It still seals, but I guess maybe the table is now warped?

I can't imagine what caused it, but obviously something I want to avoid in the future. I did wash it in a small amount of washing up liquid and cold water, and my practice room has a large window and the other day both sax and mouthpiece were sitting in the sun (rare!).

Any thoughts on how that can possibly happen?
never experienced this myself.
But from your story I would think that maybe the heat from the sun caused a (small) deformation in your mouthpiece, resulting in it playing badly.
So I would try again after your mouthpiece has had time to cool down evenly. And hope that the deformation is not permanent.
 
I had a teacher once who was convinced that mouthpieces could just die, I’ve never experienced it myself but he was convinced. Without some sort of damage being done I don’t see why it should happen, any problems I might have can usually be tracked back to the person doing the blowing or the reed.
 
Do you leave a lig and under pressure 24/7
Ligs can warp a HR mouthpiece.

The opperate if HR is the RUBBER part. It can flex and lose its proper shape.

The table can go convex lengthwise which is a really bad situation for a mpc.
 
Thanks everyone. I've tried new reeds, and any other mouthpiece I've tried is fine.

Do you leave a lig and under pressure 24/7
Ligs can warp a HR mouthpiece.

The opperate if HR is the RUBBER part. It can flex and lose its proper shape.

The table can go convex lengthwise which is a really bad situation for a mpc.
I haven't really done that, but I do tend to leave a rovner lig on loosely tightened. I suppose I could have accidentally over tightened and left it on.

I did leave as I say with the lig and reed on and under tension, in the sunlight through a window. I'm sure it must be that. Albeit surprising, I'm sure lots of people play outside in direct sunlight.

Anyway I've ordered another one!
 
Thanks everyone. I've tried new reeds, and any other mouthpiece I've tried is fine.


I haven't really done that, but I do tend to leave a rovner lig on loosely tightened. I suppose I could have accidentally over tightened and left it on.

I did leave as I say with the lig and reed on and under tension, in the sunlight through a window. I'm sure it must be that. Albeit surprising, I'm sure lots of people play outside in direct sunlight.

Anyway I've ordered another one!
I think you may have identified the cause.
 
H
Thanks everyone. I've tried new reeds, and any other mouthpiece I've tried is fine.


I haven't really done that, but I do tend to leave a rovner lig on loosely tightened. I suppose I could have accidentally over tightened and left it on.

I did leave as I say with the lig and reed on and under tension, in the sunlight through a window. I'm sure it must be that. Albeit surprising, I'm sure lots of people play outside in direct sunlight.

Anyway I've ordered another one!
I think this happened to me I use Rovner ligatures and got in to the habit of leaving my Legere Reed on
the mouthpiece with a Rovner lig. I spent a few days finding the sound I wanted difficult. I took off the Rovner and put
On a basic two screw Link lig and it cured it, go figure.
Dale
 

Social

New! Social Feeds

Look out for the navigation icon:

Follow CafeSaxophone

Latest Song of the Month

Trending

Forum statistics

Topics
32,072
Messages
578,573
Members
8,133
Latest member
walthang
Back
Top Bottom