Mouthpieces mouthpiece position on cork

Complicated question.

First, the length of cork is arbitrary. So you can't make any judgements about your technique based on that.

However, having to push in too much could indicate a problem with voicing that needs to be fixed. So when you push in, can you still play the entire range of the horn in tune with a normal amount of effort? If so, you're probably fine. If you're having to make a lot of embouchure/voicing changes to stay in tune for the whole range, then maybe you have an embouchure problem.
 
I have some tenor mouthpieces that I can't use on my Martin Committee saxes. The bore is too small? The O.D. is too wide? Solder on an extension? Sand down the cork, if possible.

The mouthpiece is a part of the saxophone. I use to take a look at the original mouthpiece when I buy/try a new mouthpiece. A Brilhart and other mouthpieces in same style is most of the times playing well on a "The Martin".
 
Complicated question.

First, the length of cork is arbitrary. So you can't make any judgements about your technique based on that.

However, having to push in too much could indicate a problem with voicing that needs to be fixed. So when you push in, can you still play the entire range of the horn in tune with a normal amount of effort? If so, you're probably fine. If you're having to make a lot of embouchure/voicing changes to stay in tune for the whole range, then maybe you have an embouchure problem.
Hi Lydian,when the mp is pushed to about 3mm from the end of the cork i can play the entire range of the horn with normal amount of effort in tune.thank you for replying ,mally
 
Also, mouthpieces have different lengths. A Jumbo Java, for example, covers much more cork than another Vandoren 'piece like the V16.

My first question, though, would be where are you playing? If it's somewhere cold(er than a normally heated room) then this will affect how far you have to push the mouthpiece onto the neck.
 
If you cut the cork short then the end of the cork is in a different place compared to where it was when it was longer.

On some horns, with some mouthpieces, the mouthpiece needed to be past the end of the cork. I wrapped a little tape round the neck at the end of the cork to guide positional placing.

There are several posts on here describing how to find the best place for the mouthpiece

Long tube notes should be in tune with short tube notes. Over blow a low C1 an octave to C2, and compare. Continue with C1 to G2 and C3.

Once these match, with the least amount of embouchure input, that's the sweet spot. Play there.
 
You could try a MP with a smaller Chamber.
My OL NY (XL Chamber) is perfect in Tune over the whole Horn on my 16M, nearly good on my YTS32 and always too low on an older Toneking (1971).
My Jody Jazz medium Chamber is perfect on the YTS and slghtly out of Tune on the other named Horns in opposite Directions.
 

Similar threads... or are they? Maybe not but they could be worth reading anyway 😀

Social

New! Social Feeds

Look out for the navigation icon:

Follow CafeSaxophone

Latest Song of the Month

Trending

Forum statistics

Topics
32,072
Messages
578,565
Members
8,133
Latest member
walthang
Back
Top Bottom