Tech/maintenance How to fix sticky pads - stop them sticking

Solution
I use 1000 grit wet-or-dry sandpaper cut into a strip slightly wider than the tone hole. I wet the paper side with Naptha (lighter fluid) and pull it out from under the pad several times with light pressure with the paper side up. This cleans the surface of the pad and also the top of the tonehole. If this doesn't work, I remove the key, clean the pad again and rub a generous amount of fine teflon powder into the pores of the pad and brush/blow away the excess. If the pad sticks again after that process, it gets replaced.
I use paper in between the pad and tonehole when the sax is not in use. Not cigarette paper (too thin) and Not a business card (too thick). Something like a piece of simple plain A4 printer paper cut too shape. I worry that a too thick card will lose the shape and "indent" of the toneholeedge on the pad, thus losing a good seal when playing.
I had a particularly stubborn alto where both normally closed large pads would stick terribly. This was a cheap sax and I gigged it hard. Cured it completely when I started using paper as I describe.
Yup. Good call! Yes, the cig paper is very thin. A bonus in regards to not abusing the relationship between the tonehole and pad but as I mentioned previously, it's prone to ANY moisture. So is the printer paper, but not nearly as much so.
I was just playing my alto earlier while teaching a lesson and I'm about to go upstairs and play again. I guaranfreakingtee you the G# pad will be sticking like a mofo........again. I'll try the regular paper thing and suspect it'll work because I've given that damn pad enough baths of Naphtha it should be drunk by now.
Thanks for the idea!

Edit- Oh, as PigSquealer also stated, what you drink prior to and during playing is a HUGE factor. If I have a soda (pop, or whatever your preferred term is) before playing, it's sticky pad city. I try to drink only water before I play but that's obviously not always successful for me!
And Colin......yes, it could also be pad coating but since I've done all of the work on my horn and installed all of the pads, etc. I know that's not the issue with me as I don't coat my pads with anything prior to installation.

J.
 
Vote:
Upvote 0
What do they treat a modern pad with? I have owned and played old Weltklang, B&S Amati... terrible pads if I compare to the new and modern pads that were available on other saxes. But they were not sticknig so much. Modern saxes had softer skin and they didn't make so much noise. And sealining better as well. Much better for a year or so. I remember one brand that was using the new soft pads with a Selmer style resonators/reflectors that were nickel plated. Suddenly there were small black spots on the pads. After some weeks the spots became holes in the skin. The same pads with plastic reflectors didn't have the problem. So what do they put on the pads?
 
Vote:
Upvote 0
Also be careful of what you eat or drink prior to playing. Sugars (soft drinks) and foods that contain starches can be cause. This may eliminate the necessity for your need of fixing.
This may have been said earlier in the thread, but I always brush my teeth before playing. Doesn't everyone, where possible?

It occurred to me early on that this is good practice in order to try and keep contamination down to a minimum. I'm finding tenor playing particularly spit prone compared to alto. Not sure why, could just be a period of adaptation maybe? Plastic key touches on the Jericho don't help either - they'll have to go when I have time.
 
Vote:
Upvote 0
This may have been said earlier in the thread, but I always brush my teeth before playing. Doesn't everyone, where possible?

It occurred to me early on that this is good practice in order to try and keep contamination down to a minimum. I'm finding tenor playing particularly spit prone compared to alto. Not sure why, could just be a period of adaptation maybe? Plastic key touches on the Jericho don't help either - they'll have to go when I have time.
Plastic key touches and saliva production, whether or not you've use the Colgate, seems a bit of a stretch
 
Vote:
Upvote 0
Don’t think so. It’s kerosene based and doesn’t readily evaporate.
Naphtha and kerosene are both different refinement grades of crude.
Naphtha is used as a cut for gasoline 3:1 this only lowers the octane about 2 points. A gallon of naphtha cost about 1/3 of a gallon of gasoline. Aviation fuel is not close to either. I have no idea on charcoal lighter fluid. Could be made from bacon fat.
 
Vote:
Upvote 0
I use paper in between the pad and tonehole when the sax is not in use. Not cigarette paper (too thin) and Not a business card (too thick). Something like a piece of simple plain A4 printer paper cut too shape. I worry that a too thick card will lose the shape and "indent" of the toneholeedge on the pad, thus losing a good seal when playing.
I had a particularly stubborn alto where both normally closed large pads would stick terribly. This was a cheap sax and I gigged it hard. Cured it completely when I started using paper as I describe.
Why do you think cigarette paper being too thin is a concern? I use it effectively to prevent stickiness on my soprano. I like it best exactly because it’s thin and it conforms to the tone hole imprint on the pad.
 
Vote:
Upvote 0
Why do you think cigarette paper being too thin is a concern? I use it effectively to prevent stickiness on my soprano. I like it best exactly because it’s thin and it conforms to the tone hole imprint on the pad.

I guess it probably comes down to my laziness. I would guess that cigarette paper has a very very finite lifespan for that use as it is so thin and delicate. A standard piece of A4 will last me 6 months easily.
 
Vote:
Upvote 0
I guess it probably comes down to my laziness. I would guess that cigarette paper has a very very finite lifespan for that use as it is so thin and delicate. A standard piece of A4 will last me 6 months easily.
I’ve never used fag papers, but a sax guy I played with years ago used them - once and then threw them. Great player, and he would walk about before the gig chatting, with a couple of reads soaking on his lip, and a cigarette in his spare hand!
 
Vote:
Upvote 0
I would think paper from a coffee filter Would be adequately more absorbent and more sturdy. I’m thinking cigarette paper dissolving and sticking. Sounds like a mess in the works.
I’ve been using cigarette paper for a decade and never had an issue with them dissolving or sticking. Quite the opposite. They absorb humidity very fast and are useable for many months before needing to be replaced. And they are very cheap.
 
Vote:
Upvote 0
... just one reminder, make sure to get cigarette paper without the glue at the end. or else slice that glue edge off before using it. we want the paper, not the glue on the pads.
 
Vote:
Upvote 0
I’ve been using cigarette paper for a decade and never had an issue with them dissolving or sticking. Quite the opposite. They absorb humidity very fast and are useable for many months before needing to be replaced. And they are very cheap.

I stand corrected, I really thought they would be very delicate. It would seem that pretty much any paper will do the trick then, so long as it has some absorbent qualities. Good to know.
 
Vote:
Upvote 0
Pad paper wo powder is also fine! Some kind of padswab/pad dryer is also good. It not the paper that make pads less sticky. You should take of the pads on regular basis (after every time you have been playing, once a week ....) and not wait to the sticky pads is a fact.

Instead of paper I use this:
padswab.webp
 
Vote:
Upvote 0

Similar threads... or are they? Maybe not but they could be worth reading anyway 😀

Social

New! Social Feeds

Look out for the navigation icon:

Follow CafeSaxophone

Latest Song of the Month

Trending

Forum statistics

Topics
32,075
Messages
578,648
Members
8,134
Latest member
banjo
Back
Top Bottom