Tech/maintenance How to fix sticky pads - stop them sticking

Solution
I use 1000 grit wet-or-dry sandpaper cut into a strip slightly wider than the tone hole. I wet the paper side with Naptha (lighter fluid) and pull it out from under the pad several times with light pressure with the paper side up. This cleans the surface of the pad and also the top of the tonehole. If this doesn't work, I remove the key, clean the pad again and rub a generous amount of fine teflon powder into the pores of the pad and brush/blow away the excess. If the pad sticks again after that process, it gets replaced.
UPDATE. On my SML. alto the lower stack D and E keys started sticking again so that’s 9 months or so. What I don’t know is whether I put to little or too much as they are the only 2 that show any signs of it returning and I had all the springs retensioned in November Too make them faster.

so I drenched one and went sparingly on the other.

@Stephen Howard .... as you were interested.
 
Vote:
Upvote 0
for sticky pads i always used to use lighter fuel until the sainted willy garnett in putney gave me a little colman's english mustard bottle containing paraffin. since then i always tell people i clean them with mustard. paraffin works really well and seems less drying than lighter fuel.
 
Vote:
Upvote 0
Ok so I’ve recently acquired a MkVI tenor and it’s had a re-pad by a competent tech (recognised and recommended on here and he’s done all my work for years). The pads are pisoni’s. It’s been playing fine for the last few weeks and then suddenly the whole upper stack has become sticky over the last week or so. The C or A keys will intermittently release late, G# sticks if I put the horn down mid session for 10minutes or so (key leaves in between sessions stop this) It doesn’t begin at the start of the session only once there’s a bit of moisture in the instrument.
I’m fastidious with not eating or drinking before I play and have never suffered like this before.
I’ve tried the lighter fluid/dollar bill remedies to no avail. They work temporarily and then it comes back. It’s starting to drive me crazy....
I’m almost tempted to strip down the upper stack and give everything a good clean (I’m quite happy/skilled enough to do this). Before I go to that extent has anyone encountered anything like this before and if so how did you remedy it?
 
Vote:
Upvote 0
Have a look here.

Then @just saxes can probably elaborate on the subject although he already said a lot.
Thanks, this is a really interesting thread. I’m kind of hoping A thorough cleaning does The trick as I’m trying to avoid adding anything to what should be top notch new pads... I don’t really want to have to shell out for another repad on the top stack having only just had them replaced.
 
Vote:
Upvote 0
Thanks, this is a really interesting thread. I’m kind of hoping A thorough cleaning does The trick as I’m trying to avoid adding anything to what should be top notch new pads... I don’t really want to have to shell out for another repad on the top stack having only just had them replaced.

If your pads are Lucien-Deluxe, don't change them, IMO. They are my choice out of everything out there, and I've used or encountered just about everything out there. The porousness of the skin is fine, the woven felt and skin both survive the abuse of spit, time and wear extremely well -- better than anything (IME) that Prestini makes other than kangaroo (but there, you're getting into porosity issues and other things I'm not going to mention in the interest of not starting a fire, here).

You just need a good nonstick treatment. And to not eat or drink things with calories in them before playing. Anything with caloric content, when bits of it reach the pads, will encourage films to develop and biomass to grow.
 
Vote:
Upvote 0
I’m almost tempted to strip down the upper stack and give everything a good clean (I’m quite happy/skilled enough to do this). Before I go to that extent has anyone encountered anything like this before and if so how did you remedy it?

If your horn's been recently repadded I'd be very surprised if it hadn't been cleaned while it was disassembled - and unless you've put anything down it since (unlikely), I doubt that stripping it down would solve any problems.
I suppose there's a small chance that the tonehole rims might be rough - but, again, this would be very unlikely...especially on an old Selmer.

Is the action much lighter than it was before? It sometimes happens that the spring tension is set a little too 'optimistic', and this can lead to problems with sticking pads.
 
Vote:
Upvote 0
If your horn's been recently repadded I'd be very surprised if it hadn't been cleaned while it was disassembled - and unless you've put anything down it since (unlikely), I doubt that stripping it down would solve any problems.
I suppose there's a small chance that the tonehole rims might be rough - but, again, this would be very unlikely...especially on an old Selmer.

Is the action much lighter than it was before? It sometimes happens that the spring tension is set a little too 'optimistic', and this can lead to problems with sticking pads.

Thanks Stephen! I’ve actually solved it. I took a large Yamaha pull through that’s quite bulky, wetted it (dripping wet) and put it through the bore about 10 times rising between each time. once everything was dry I then re cleaned the pads with lighter fluid, dollar billed each tone hole and today played for 3hours stick free.

No idea how something sticky got inside it, but whatever it was was only causing an issue once it got damp. The horn was well cleaned during re-padding so I have absolutely no idea what caused it. My tech also replaced some pads on my other tenor and my alto and I’ve had no problems with either of those horns. I can only guess it was something in my saliva that made a mess but as I said in my first post I’m fastidious about not eating or drinking anything before playing (learned that lesson as a beginner 8 or so years ago with sticky g# keys). Hopefully I can go back to enjoying a trouble free horn again (fresh pads have made the old girl really sing!)
 
Vote:
Upvote 0
Glad you got it sorted!
Sounds to me like there must have been something on the pads that was water soluble rather than the usual gunk that dissolves in lighter fluid.
It's not uncommon on older pads - which is why I usually advise a water/saliva clean followed by a solvent clean - but I don't think I've come across it on new pads.
 
Vote:
Upvote 0
Glad you got it sorted!
Sounds to me like there must have been something on the pads that was water soluble rather than the usual gunk that dissolves in lighter fluid.
It's not uncommon on older pads - which is why I usually advise a water/saliva clean followed by a solvent clean - but I don't think I've come across it on new pads.

Agree with all, but I would say check the toneholes for burrs around the lips, anyway.
 
Vote:
Upvote 0
Hello, I have time and again problems with sticky pads (most notoriously Bb-key, g#-key, and the octave key of my Yamaha Bass Clarinet, the last being the worst).

Would it make sense tu use some kind of lubrification like silicone or teflon or graphite to diminish their tendency to stick closed?
 
Vote:
Upvote 0
A common remedy is to remove the key and to clean both the pad and the tonehole with naptha (lighter fluid) on a cotton bud. I have also had good success on stubborn pads rubbing a bit of teflon powder into the surface with my index finger and blowing away the excess after cleaning.
 
Vote:
Upvote 0
Yamaha pad paper is another product which works OK.....

But the two suggestions @jbtsax made above are just as worthy, possible more so. The teflon powder works....I have also heard others sprinkle it onto both sides of paper currency then run the bill between the pad and tonehole, when key is in closed position.
 
Vote:
Upvote 0

Similar threads... or are they? Maybe not but they could be worth reading anyway 😀

Social

New! Social Feeds

Look out for the navigation icon:

Follow CafeSaxophone

Latest Song of the Month

Trending

Forum statistics

Topics
32,075
Messages
578,650
Members
8,134
Latest member
banjo
Back
Top Bottom