SopranoSimon
Member
- Messages
- 160
- Location
- Darlington
Anyone know the best way to stop pads sticking?
What's teflon powder, please, and where do I find some? Going to try all of your suggestions on my 'sticky' G# key. The spring has been adjusted, and alto just serviced, so huge thanks for the above..My technique is to clean the pad using a flattened cotton bud (Q-tip) and naptha (lighter fluid). Next I pull a strip of 1000 grit wet or dry sandpaper abrasive side down between the pad and the tone hole using moderate pressure on the key several times. Most of the time this corrects the sticking pad. If it does not the pad gets a light application of teflon powder where the tonehole contacts the leather---being sure to blow away any excess powder.
At this point if the pad is still sticky I remove the key and check the tonehole for "burrs". If burrs are found, they are removed and the key is reinstalled. If no burrs are present the pad is replaced. You can find burrs by feeling around the sides of tonehole with your index finger in an up and down motion. A burr will feel "sharp and rough" instead of smooth.
Strengthening the spring on the bis might help, but that is overcoming the "symptom" rather than addressing the real problem and may interfere with the regulation which is sensitive in that area of the saxophone.
I’ve got key leaves. They work great for me.Deb, I keep my G# key open at all times when in the case. You can buy "leaves" to do this, or use other means. I no longer have sticky G# key issues.
On my newer saxes I keep my C# open which keeps the G# open. Just a thought for you to consider.
I'll give it a try. Thank you. XDeb, I keep my G# key open at all times when in the case. You can buy "leaves" to do this, or use other means. I no longer have sticky G# key issues.
On my newer saxes I keep my C# open which keeps the G# open. Just a thought for you to consider.
I get my teflon powder from JL Smith. I just looked and you can buy it on Amazon UK. Be sure to search for "PTFE" powder instead of "teflon". It is commonly used by piano technicians as well if there are any suppliers in your area.What's teflon powder, please, and where do I find some? Going to try all of your suggestions on my 'sticky' G# key. The spring has been adjusted, and alto just serviced, so huge thanks for the above..
No. Keeping a normally closed key open should not weaken the spring any more than opening the key repeatedly when you play.Doesn't that weaken the springs? (Keeping them open). I used to put thin paper in them in the case, but recently, I haven't had the problem with those pads. I just make sure they're open when I take the sax out.
What is a roo pad please? XI had these issues
I am now using Roo Pads and have had no difficulties for the last year... since fitting the Roo Pads
What is a roo pad please? X
That is true, however I know of some folks who just have their G# key pad replaced with a "roo". Roo pads have less of a tendency to get "sticky" due to the fact that they have no waterproofing coating on the surface. But,they will get sticky like any other pad when a sax is poorly maintained.Roo pads are pads made from kangaroo leather.
Roopads
You would need to get your sax repadded to use them, so try the other options first as this can be expensive.
