SopranoSimon
Member
- Messages
- 160
- Location
- Darlington
Anyone know the best way to stop pads sticking?
No one has yet mentioned pulling a strip of 1000 grit wet or dry sandpaper between the pad and tone hole a few times---abrasive side down of course. I do this in conjunction with cleaning the pad with a Q-tip (cotton bud) soaked in naptha. I am also finding more and more pads that make a sticking sound that is caused by burrs not removed from around the tops of leveled toneholes. Some of these are from the factory and some from a lazy tech who previously worked on the instrument.
No problem. The amount of material removed by a few passes of the 1000 grit is so infinitesimal that you are basically cleaning and "polishing" the brass surface.What about those with rolled tone holes
Sandpaper: What about the emery boards that are super fine?
I use craft sanding sticks that go up to 800 grit which I suppose would be fine enough, but I like the idea of the entire surface of the tonehole being "wiped" at the same time. It just seems that a more "uniform" job is possible. I wouldn't see a problem using one on a palm key tonehole if it covered the entire surface.Sandpaper: What about the emery boards that are super fine?
I actually think it is illegal to send combustibles through the mail. Isn't it in UK or USA?In principle, you can ship anything anywhere. Just need to make sure you follow the carrier's rules. That's up to the sender.
I understand that the old time trick was a $20 bill slid under the pad and gently pulled out... Interesting and quirky!!!
