Saxophone beginners Clarification: Alto neck Ab concert?

Nederveen in "acoustical aspects of woodwind instruments on p. 87 writes:
In two places alto and tenor saxophones have bends in the bore. The crook in the upper part of the bore shows very low curvature and does not exercise any appreciable difference. The reverse is the case for the sharp bend in the lower part. This bend affects only the lowest notes and does not even come into play for the upper register. . . In section 37 it was shown that such sharp bends correspond to a shortening and widening of the equivalent straight tube, where the differences may be of the order of 5% for the curved parts.
With regard to the wall material having an effect upon the soundwaves inside the tube, this is from a study entitled:
"Influence of Wall Vibrations on a Simplified Wind Instrument" by Nief, Gautier, Dalmont, and Gilbert
. . . in order to obtain measurable effects of wall vibrations, the geometrical parameters of the studied tube have to be
unusual compared to that of real instruments. For a slightly oval-shaped and very thin brass tube [.2 mm], it is shown theoretically and experimentally that a coupling between the inner plane acoustic wave and ovalling mechanical modes occurs and results in disturbances of the input impedance, which can slightly affect the tone color of the sound produced. It is concluded that the reported effects are unlikely to occur in real instruments except for some organ pipes.
I have measured several vintage and new tenor necks in my shop and the wall thickness at the small end averages about 1.8 mm. The wall thickness at the large end before the tenon averages 1.5mm. A thickness of .65mm is quite unusual where American and Japanese made instruments are concerned.

It is widely known and accepted that the "interior geometry" of a woodwind instrument has a great deal of influence over the sound. Claims that wall material, finishes, adding mass etc. make a difference are still present in saxophone lore, but to date there has been no peer reviewed scientific research to back up any of those claims.
 

Attachments

I guess the form of the curve in the neck is mainly responsible for the type of sound the player requires.
Selmer's curve has become wider over the years which result in a deeper sound, while the abrupt curve in the end of the neck of the Lyrist results in a faster airflow and more overtones. But also the thickness of the material results in different. builtup of overtones. The thicker, the duller the sound (0.8). Too thin (below 0.6) becomes too edgy. The abrupt curve in the neck of the Lyrist in combination with the thinner material (0.65) and the insufficiant support however makes it more vulnerable for bending and that's one of the reasons that not many Lyrists survived. The start of the necktube is only 12mm inside, which is smaller than alto! The tone is better though than any other brand and to me it is the Stradivarius among saxophones.

It is interesting to note that in the evolution of the instrument, this design was a dead end.
 

Similar threads... or are they? Maybe not but they could be worth reading anyway 😀

Social

New! Social Feeds

Look out for the navigation icon:

Follow CafeSaxophone

Latest Song of the Month

Trending

Forum statistics

Topics
32,079
Messages
578,717
Members
8,136
Latest member
peterdehelegrote
Back
Top Bottom