noelweston
Member
- Messages
- 93
- Location
- Hessle, East Yorks
OK, a couple of people have expressed an interest following discussions in the hot air torch thread, so I've uploaded the STL files for my hot air torch holder and other attachments.
The STL files should be here:
and the openscad files here:
Bear in mind these have been created and adapted for my own work space, so may need adjusting for different benches etc.
The bolts are M12 - I generally find I need to run taps and dies on all the threads to make them work smoothly, but your printers may produce cleaner prints.
I think the tops should now fit without any finessing, but if they're stiff then some fine sandpaper sorts them out.
Enjoy!
The STL files should be here:
and the openscad files here:
Bear in mind these have been created and adapted for my own work space, so may need adjusting for different benches etc.
The bolts are M12 - I generally find I need to run taps and dies on all the threads to make them work smoothly, but your printers may produce cleaner prints.
I think the tops should now fit without any finessing, but if they're stiff then some fine sandpaper sorts them out.
Enjoy!
